Specifications

09 / 2003
ARRICAM Lite
ARRICAM Lite Extended camera control panel
ARRICAM Lite Extended Camera Footage Display
ARRICAM System Guide 11
ARRICAM Lite
The ARRICAM Lite (LT) is a very small and lightweight 35mm camera
for Steadicam and hand held work. Magazines are back mounted. The
Lite camera control panel contains the following controls: RUN button,
RUN LED, PHASE button, fps setting, fps display, shutter setting and
shutter display, as well as a BRIGHT button to adjust the brightness of
all LED displays on the camera. The FPS and shutter displays will also
show warning messages. The integrated footage display counts
EXPOSED FILM and RAW STOCK. The same controls can be found
on the ARRICAM Studio. The film gate can accept an aperture format
mask and a gel filter holder. The internal heater is thermostatically con-
trolled and is automatically activated in low temperatures.
Included in the camera package are: Lite Viewfinder or Lite Universal
Viewfinder, Lite Eyepiece or Lite Universal Eyepiece, film gate, filter
holder, aperture format mask set.
Compatibility: Studio and Lite share the same field lenses and ground
glasses. The ARRICAM ground glasses do not fit in MOVIECAM or
ARRIFLEX cameras. The aperture format masks and gel filter holders
are the same as used in ARRIFLEX cameras. For shooting Super 35 in
ANSI format with an ARRIFLEX 435 or 535 camera, special ground
glasses and aperture format masks are available. In that case, timecode
cannot be recorded on the ARRIFLEX cameras.
The camera accepts the Lite Steadicam and Shoulder Magazines in back
load position. With the Studio Mag to Lite Camera Adapter the Studio
Magazine 120/400 and 300/1000 can also be mounted in back load
position. The ARRICAM lens mount accepts all LDS and non-LDS
PL mount lenses for 35 mm film cameras.
K0.60005.0 ARRICAM Lite 4 p with Lite Viewfinder
K0.60006.0 ARRICAM Lite 4 p with Lite Universal Viewfinder
K0.60008.0 ARRICAM Lite 3 p with Lite Viewfinder
K0.60010.0 ARRICAM Lite 3 p with Lite Universal Viewfinder
Speed: 1-40 fps forward, 1-32 fps reverse
(reverse can be set with the Speed Control Box,
Wireless Remote Control or ARRIMOTION system;
camera runs reverse only with Studio magazines)
Shutter: electronic shutter from 0° to 180°, adjustable in 0.1°
increments. For ramps the range of 11.2° to 180°
can be used.
Movement: 5-link with dual-pin registration and dual transport
claws, 4 or 3 perforation (4 p or 3 p).
Lens Mount: 54 mm PL with Lens Data System contacts.
Switchable to Super 35.
Power: 24 V DC, all fuses are self-resetting.
Sound: less than 24 db/A