Specifications

09 / 2003
ARRICAM Studio
10 ARRICAM System Guide
ARRICAM Studio
The ARRICAM Studio (ST) is a very quiet 35mm sync sound production
camera. Magazines can be top or back mounted. The basic controls are
built into the Studio camera control panel (see second picture): RUN
button, RUN LED, PHASE button, fps setting, fps display, shutter
selector and shutter display, as well as an UNLOCK button to activate
the fps and shutter selector buttons, and a BRIGHT button to adjust
the brightness of all LED displays on the camera. The FPS- and shutter
displays will also show warning messages. The integrated footage display
counts EXPOSED FILM and RAW STOCK. The same controls can be
found on the ARRICAM Lite. Other controls on the Studio are a
DUST CHECK button and a beeper volume dial. The film gate accepts
an aperture format mask and a gel filter holder. The internal heater is
thermostatically controlled and is automatically activated in low tem-
peratures.
Included in the camera package are: Studio Viewfinder or Studio
Universal Viewfinder, Studio Eyepiece, Top Load Adapter, film gate,
filter holder, aperture format mask set.
Compatibility: Studio and Lite share the same field lenses and ground
glasses. The ARRICAM ground glasses do not fit in MOVIECAM or
ARRIFLEX cameras. The aperture format masks and gel filter holders
are the same as used in ARRIFLEX cameras. For shooting Super 35 in
ANSI format with an ARRIFLEX 435 or 535 camera, special ground
glasses and aperture format masks are available. In that case, timecode
cannot be recorded on the ARRIFLEX cameras.
The camera accepts the Studio Magazine 120/400 and 300/1000 in top
load or back load position. With Lite Mag to Studio Camera Adapter
the Lite Steadicam and Shoulder Magazines can also be mounted in
back load position. The ARRICAM lens mount accepts all LDS and
non-LDS PL mount lenses for 35 mm film cameras.
K0.60001.0 ARRICAM Studio 4 p with Studio Viewfinder
K0.60002.0 ARRICAM Studio 4 p with Studio Universal Viewfinder
K0.60007.0 ARRICAM Studio 3 p with Studio Viewfinder
K0.60009.0 ARRICAM Studio 3 p with Studio Universal Viewfinder
Speed: 1-60 fps forward, 1-32 fps reverse
(reverse can be set with the Speed Control Box,
Wireless Remote Control or ARRIMOTION system;
camera runs reverse only with Studio magazines)
Shutter: electronic shutter from 0° to 180°, adjustable in 0.1°
increments. For ramps the range of 11.2° to 180°
can be used.
Movement: 5-link with dual-pin registration and dual transport
claws, 4 or 3 perforation (4 p or 3 p).
Lens Mount: 54mm PL with Lens Data System contacts.
Switchable to Super 35.
Power: 24 V DC, all fuses are self-resetting.
Sound: less than 20 db/A
ARRICAM Studio: Extended camera control panel
Frameglow Mask | Ground Glass
Aperture Format Mask | Film Gate Gel Filter Holder