User's Manual

21
After heating finished PA will stay in
STBY mode and Main display will
appear.
Depending on CAT settings you would have two possible situation illustrated. If NO CAT was saved,
above display will be visible. To set band and segment for transmitting, use BAND and SEGMENT
buttons. In this mode exact frequency will be read from the TCVR and PA will set up on it
automatically.
Another display appears, if CAT was defined but TCVR is not connected with the PA (CAT cable).
See the following pictures.
FREQ button has two functions. It
allows to display working frequency or
active band segment.
Also in this case frequency will be read
directly from the TCVR in operation
mode.
If TCVR is not connected with the PA
(RF cable), frequency cannot be read.
Use ANTENNA (left/right) to select one
of preprogramed antenna for that band.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.