User's Manual

UPGRADE touch button can be used

ONLY in the case if EEPROM or

firmware files (or both) will be

upgraded. In such a case ask dealer or

manufacturer for the exact procedure.

5.3. Preparing for operation

In STBY the amplifier is in bypass-mode and your transceiver is directly connected to

the antenna. Maximum allowed power in bypass mode is 200 Watts! Passing RF

power is displayed if PA is in standby mode.

To turn PA ON press ON/OFF button on the front panel (black one) and hold it abt. 1 second. PA

will start tube heating. It will take 180 seconds. Turning PA ON is possible ONLY from the home

screen! If you have other display active, press EXIT more times to go back to the home screen.

Time to go is visible on the display.

Wait until heating finish.

Type of supported TCVR and

working

frequency are visible on the

display.

AUTO LED is ON.

Type of supported TCVR and

working

frequency are visible on the

display.

AUTO LED is ON.

PAGE 1
UPGRADE button can and be used Type oftouch supported TCVR ONLY in the case if EEPROM working or firmware files (or both) will be frequency visibleask ondealer the or upgraded. In suchare a case manufacturer for the exact display. procedure. AUTO LED is ON. 5.3. Preparing for operation In STBY the amplifier is in bypass-mode and your transceiver is directly connected to the antenna. Maximum allowed power in bypass mode is 200 Watts! Passing RF power is displayed if PA is in standby mode.
PAGE 2
After heating finished PA will stay in Type of supported TCVR and STBY mode and Main display will working appear. frequency are visible on the display. AUTO LED is ON. Depending on CAT settings you would have two possible situation illustrated. If NO CAT was saved, above display will be visible. To set band and segment for transmitting, use BAND and SEGMENT buttons. In this mode exact frequency will be read from the TCVR and PA will set up on it automatically.