Product manual

I N S TA L L A TI O N I N S T R U C TI O N S
External Monitor Input
STEP 10- OFF AIR MONITORING
The Monitor Selector Switch has an External Input position (AIR). This position is usually used to monitor the actual radio station on air signal from a radio tuner.
NOTE: it is important to monitor the actual signal from the radio station and not just the output of the console. This is so as to monitor the entire radio chain
from the console to the transmitter.
INSTALLATION
Connect the output of a radio tuner or professional on air monitor to the AIR IN connector on the back of the console.
IMPORTANT: if using a consumer tuner, use a line level output and not the speaker output.
CALIBRATION
The AIR IN is calibrated to -10dBu input level. Interior trimpots may be factory adjusted to different levels.
TEST
Set up the tuner or monitor to your station’s frequency and switch the console control room monitor to the AIR position. You should hear the audio output of the
tuner. Audio quality should be high and there should be no objectionable audio hum.
STEP 10- OFF AIR MONITORING
RADIO RECEIVER
Tuner or Off Air
Monitor Output
Logic
RS232
DC Power
Cue
Ch 9
In
Phone
Logic
Pgm Left Pgm Rght Phone Ch 10 Phone
Out Out Out In
PC
USB
Mic 1
In
Mic2
InIn In In In In In
Ch 8 Ch 7 Ch 6 Ch 5 Ch 4 Ch 3
48V
pwr
Ch 9
Out
Pgm
Out
Aud
AMM
PMM
Out
Mon
In
Air
In
Back panel Diagram for ARC-10U (unbalanced base model) & ARC-10UP (unbalanced with PC model)
Ch 8 Ch 7 Ch 6 Ch 5 Ch 4 Ch 3
In In In In In In
ARC-10BP (balanced with PC model)
RJ45 balanced
audio connectors
4.11