Product manual

I N S TA L L A TI O N I N S T R U C TI O N S
Program Output
STEP 6- CONSOLE PROGRAM OUTPUT
The console has both balanced and unbalanced Program bus outputs
UNBALANCED PROGRAM OUTPUT
The console program output (PGM) is located on the console back panel. It is an unbalanced (-10dBu) audio output.
BALANCED PROGRAM OUTPUT
The console program output (PGM) is located on the console back panel. It is a balanced (+4dBu) audio output on XLR connectors.
CONNECTING THE PROGRAM OUTPUT TO THE SIGNAL CHAIN
The console Program output is both unbalanced analog (-10dBu level) and balanced (+4dBu). The Audition output is unbalanced. In either case, the equipment
that the Program output drives must accept one of these input types and levels. You must refer to the product manual for that product. In some cases, it
may be useful to connect the Program output of the console to an audio distribution amplifier which is designed to connect analog audio products that are
of different types and levels.
TEST
- The Program output of the console is connected to additional equipment (processor, distribution amp, etc) to form a signal chain. Check for pres-
ence and quality of audio at each point along the signal chain.
STEP 6- connect the console Program output to the station’s Signal Chain
Logic
RS232
DC Power
Cue
Ch 9
In
Phone
Logic
Pgm Left Pgm Rght Phone Ch 10 Phone
Out Out Out In
PC
USB
Mic 1
In
Mic2
InIn In In In In In
Ch 8 Ch 7 Ch 6 Ch 5 Ch 4 Ch 3
48V
pwr
Ch 9
Out
Pgm
Out
Aud
AMM
PMM
Out
Mon
In
Mon
In
Back panel Diagram for ARC-10U (unbalanced base model) & ARC-10UP (unbalanced with PC model)
Ch 8 Ch 7 Ch 6 Ch 5 Ch 4 Ch 3
In In In In In In
ARC-10BP (balanced with PC model)
RJ45 balanced
audio connectors
Balanced Pgm out (+4dBu)
Unbalanced Pgm out (-10dBu)
4.7