Product manual

I N S TA L L A TI O N I N S T R U C TI O N S
Step by Step Instructions
a) STEP 1- POWER SUPPLY INSTALLATION
The console power supply should be plugged into a surge protected outlet. First plug the power supply into the back of the console and then plug the
power supply into the AC outlet.
TEST- The console should now be on. To test for power, simply push one of the console On/off switches to see that the Channel On LED lights.
b) STEP 2- CONNECT AN AUDIO SOURCE
Select a single audio source such as a CD player. Choose a console channel for the source (such as Channel 3), and connect the audio source to the
console with a stereo audio cable. This cable is usually provided with the CD player
STEP 1- CONNECT THE
AC POWER SUPPLY
Connect a CD player to
Channel 3 on the console
STEP 2- CONNECT AN AUDIO SOURCE
STEP 3- PLUG IN
HEADPHONES TO LISTEN
Plug in a pair
of high impedance
headphones and listen
to the CD player
RCA AUDIO CABLE
The Black con-
nector is right
and the Red con-
nector is left
c) STEP 3- LISTEN TO AUDIO ON HEADPHONES
Plug the headphones into the headphone jack on the back right side of the console as illustrated. The console supports both low impedance (8 ohm) and high
impedance (>20 ohm) headphones. Play a CD as in Step 2. Select PGM on the Monitor Select Switch. Adjust the headphone level control on the console to a
comfortable audio level.
TEST- You should hear the song on the CD clearly. There should be no audible hum or noise. If you hear no audio or there is hum or noise, then repeat Steps
1,2,&3.
On the channel that you have chosen for the source (such as
channel 3), turn the channel on by pushing the red on button(the red on LED
should now be on), and bring the slide fader on that channel to the in hand
setting (0).
Insert a CD into the CD player and push the Play button on the CD
player to begin play.
TEST- The VU meters on the console should move as the CD plays a song.
IMPORTANT- Follow this STEP by STEP procedure. Each STEP has specific tests to determine if the console installation
has been performed correctly to that point.
Logic
RS232
DC Power
Cue
Ch 9
In
Phone
Logic
Pgm Left Pgm Rght Phone Ch 10 Phone
Out Out Out In
PC
USB
Mic 1
In
Mic2
InIn In In In In In
Ch 8 Ch 7 Ch 6 Ch 5 Ch 4 Ch 3
48V
pwr
Ch 9
Out
Pgm
Out
Aud
AMM
PMM
Out
Mon
In
Mon
In
Back panel Diagram for ARC-10U (unbalanced base model) & ARC-10UP (unbalanced with PC model)
Ch 8 Ch 7 Ch 6 Ch 5 Ch 4 Ch 3
In In In In In In
ARC-10BP (balanced with PC model)
RJ45 balanced
audio connectors
4.4