Product manual

I N S TA L L A TI O N I N S TR U C TI O N S
Microphones
STEP 5- CONNECT A MIC TO THE CONSOLE
Using a mic to XLR cable, connect a mic to the Mic 1 input on the console.
Turn Channel One on (the red LED should be on) and set the channel one fader to the in hand position (middle). If the mic itself has an on/off switch, then turn
it on.
TEST- Speak into the microphone and the console VU meters should follow your voice. There should be no audio out of the monitor speakers (they are muted
to eliminate feedback) but there should be audio in the Headphones.
If mic level is low, refer to “Calibration” later in this section.
STEP 5- CONNECT A MIC TO THE CONSOLE
MIC ONE
Connect a mic to the
XLR mic inputs and
test the mic
into the headphones
4.6
Back panel Diagram for ARC-15BP console
Logic
RS232
DC Power
Cue
Ch 14
In
Phone Logic Pgm Left Pgm Rght Phone Ch 15 Phone
Out
Out Out In
PC
USB
Mic Ch 4
In
Mic Ch 5
In
Ch 13 Ch 12 Ch 11 Ch 10 Ch 9 Ch 8
48V
pwr
Ch 14
Out
Pgm
Out
Aud
AMM
PMM
Out
Mon
In
Air
L
R
L
R
L
R
L
R
L
R
ARC-15BP
Headphone
Ground
Ch 7 Ch 6 Ch 5 Ch 4 Ch3 Ch 2 Mic Ch 1
In
Mic Ch 2
In
Arrakis
Systems
Mic Ch 3
In
In