User Manual
Table Of Contents
- Cover
- English
- Table of Contents
- Introduction to the ARP 2600 FS
- Block diagram
- Panel description and functions
- Front panel (PREAMPLIFIER, ENVELOPE FOLLOWER, RING MODULATOR section)
- Front panel (VCO-1 section)
- Front panel (VCO-2 section)
- Front panel (VCO-3 section)
- Front panel (VCF section)
- Front panel (ADSR EG/AR EG section)
- Front panel (VCA section)
- Front panel (MIXER, REVERB section)
- Front panel (NOISE GENERATOR, VOLTAGE PROCESSORS section)
- Front panel (SAMPLE & HOLD section)
- Front panel (SPEAKER section L, SPEAKER section R)
- Side panel L (MIDI, USB, MODE SWITCH) Side panel R (power, main output jacks)
- ARP3620 keyboard unit
- Getting started
- Let’s make some sounds
- About MIDI
- Troubleshooting
- Specifications
- Français
- Sommaire
- Un mot à propos de l’ARP 2600 FS
- Schéma de principe
- Description des panneaux et fonctions
- Panneau avant (section PREAMPLIFIER, ENVELOPE FOLLOWER, RING MODULATOR)
- Panneau avant (section VCO-1)
- Panneau avant (section VCO-2)
- Panneau avant (section VCO-3)
- Panneau avant (section VCF)
- Panneau avant (section ADSR EG/AR EG)
- Panneau avant (section VCA)
- Panneau avant (section MIXER, REVERB)
- Panneau avant (section NOISE GENERATOR, VOLTAGE PROCESSORS)
- Panneau avant (section SAMPLE & HOLD)
- Panneau avant (section SPEAKER L, section SPEAKER R)
- Panneau latéral G (MIDI, USB, MODE SWITCH) Panneau latéral D (alimentation, prises de sortie principale)
- Clavier ARP3620
- Préparations
- Production de sons
- À propos de MIDI
- Dépannage
- Fiche technique
- Deutsch
- Inhalt
- Einleitung zum ARP 2600 FS
- Blockschaltbild
- Funktionen und Regler
- Oberseite (Sektionen PREAMPLIFIER, ENVELOPE FOLLOWER, RING MODULATOR)
- Oberseite (VCO 1-Sektion)
- Oberseite (VCO-2-Sektion)
- Oberseite (VCO-3-Sektion)
- Oberseite (VCF Sektion)
- Oberseite (ADSR EG/ AR EG-Sektion)
- Oberseite (VCA Sektion)
- Oberseite (MIXER, REVERB-Sektion)
- Oberseite (NOISE GENERATOR, VOLTAGE PROCESSORS-Sektion)
- Oberseite (SAMPLE & HOLD-Sektion)
- Oberseite (SPEAKER-Sektion L, SPEAKER-Sektion R)
- Seitliches Anschlussfeld L (MIDI, USB, MODE SWITCH) Seitliches Anschlussfeld R (Netzanschluss, Hauptausgangsbuchsen)
- ARP3620 Tastatureinheit
- Vorbereitung
- Erzeugen wir nun ein paar Sounds
- Über MIDI
- Fehlersuche
- Technische Daten
- Español
- Tabla de contenido
- Introducción al ARP 2600 FS
- Diagrama de bloques
- Descripción y funciones de los paneles
- Panel frontal (sección PREAMPLIFIER, ENVELOPE FOLLOWER, RING MODULATOR)
- Panel frontal (sección VCO-1)
- Panel frontal (sección VCO-2)
- Panel frontal (sección VCO-3)
- Panel frontal (sección VCF)
- Panel frontal (sección ADSR EG/AR EG)
- Panel frontal (sección VCA)
- Panel frontal (sección MIXER, REVERB)
- Panel frontal (sección NOISE GENERATOR, VOLTAGE PROCESSORS)
- Panel frontal (sección SAMPLE & HOLD)
- Panel frontal (sección SPEAKER LEFT, sección SPEAKER RIGHT)
- Panel lateral izquierdo (MIDI, USB, MODE SWITCH) Panel lateral derecho (alimentación, jacks de salida principal)
- Unidad de teclado ARP3620
- Primeros pasos
- Creación de sonidos de ejemplo
- Acerca de MIDI
- Solución de problemas
- Especificaciones
- 日本語
- 目次
- はじめに
- ブロック図
- 各部の名称と機能
- フロント・パネル (プリアンプ、エンベロープ・フォロワー、リング・モジュレーター・セクション)
- フロント・パネル (VCO-1セクション)
- フロント・パネル (VCO-2セクション)
- フロント・パネル (VCO-3セクション)
- フロント・パネル(VCFセクション)
- フロント・パネル (ADSR EG/AR EGセクション)
- フロント・パネル (VCAセクション)
- フロント・パネル (MIXER, REVERBセクション)
- フロント・パネル (NOISE GENERATOR, VOLTAGE PROCESSORSセクション)
- フロント・パネル (SAMPLE&HOLDセクション)
- フロント・パネル (スピーカー・セクションL、スピーカー・セクションR)
- サイド・パネルL(MIDI、USB、モード・スイッチ) サイド・パネルR(電源、メイン出力端子)
- ARP 3620鍵盤ユニット
- ARP 3620鍵盤ユニット
- 演奏までの準備
- 音を出してみよう
- MIDIについて
- 故障とお思いになる前に
- 仕 様
- 3 -
Owner’s manual
IMPORTANT SAFETY INSTRUCTIONS
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including ampliers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding prong.
The wide blade or the third prong are provided for your safety. If the provided plug does not t into your
outlet, consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11) Only use attachments/accessories specied by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualied service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
• WARNING—This apparatus shall be connected to a mains socket outlet with a protective earthing connection.
• Mains powered apparatus shall not be exposed to dripping or splashing. No objects lled with
liquids, such as vases or drinking glasses, shall be placed on the apparatus.
• Turning off the power switch does not completely isolate this product from the power line.
• Keep the power plug easily accessible. Do not install this equipment far from a power outlet and/or
power strip.
• Do not install this equipment in a conned space such as a box for the conveyance or similar unit.
• Excessive sound pressure from earphones and headphones can cause hearing loss.
• This apparatus is for moderate climates areas use, not suitable for use in tropical climates countries.
• The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers,
table-cloths, curtains, etc.
• No naked ame sources, such as lighted candles, should be placed on the apparatus.
• The rating label is located on the bottom of the unit.
The lightning ash with arrowhead symbol within an equilateral triangle, is intended to
alert the user to the presence of uninsulated “dangerous voltage” within the product’s
enclosure that may be of sufcient magnitude to constitute a risk of electric shock to
persons.
The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance (servicing) instructions in the literature
accompanying the product.
THE FCC REGULATION WARNING (for USA)
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harm-
ful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
If items such as cables are included with this equipment, you must use those included items.
Unauthorized changes or modication to this system can void the user’s authority to operate this equipment.
SUPPLIER'S DECLARATION OF CONFORMITY (for USA)
Responsible Party: KORG USA INC.
Address : 316 SOUTH SERVICE ROAD, MELVILLE, NY
Telephone : 1-631-390-6500
Equipment Type : SEMI-MODULAR SYNTHESIZER
Model : ARP2600-FS
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,and (2) this device must accept any interference re
-
ceived, including interference that may cause undesired operation.
Notice regarding disposal (EU only)
When this “crossed-out wheeled bin” symbol is displayed on the product, owner’s manual, battery, or
battery package, it signies that when you wish to dispose of this product, manual, package or battery
you must do so in an approved manner.
Do not discard this product, manual, package or battery along with ordinary household waste. Disposing
in the correct manner will prevent harm to human health and potential damage to the environment. Since
the correct method of disposal will depend on the applicable laws and regulations in your locality, please
contact your local administrative body for details. If the battery contains heavy metals in excess of the
regulated amount, a chemical symbol is displayed below the “crossed-out wheeled bin” symbol on the
battery or battery package.
* All product names and company names are the trademarks or registered trademarks of their respective owners.










