User Manual

ARP 2600 FS
- 16 -
Front panel (SPEAKER section L, SPEAKER section R)
INITIAL OSCILLATOR FREQUENCY INITIAL OSCILLATOR FREQUENCY
a
b
c
d
e
f
h
i
g
SPEAKER section L
a. KBD CV-1 jack
Outputs a pitch CV when a key is pressed on the ARP 3620 keyboard. If two
keys are pressed, the pitch CV of the lower key is output.
Tip:
The KBD CV input voltage of a VCO or the VCF is the same as the output
voltage of this KBD CV-1 jack.
b. KBD CV-2 jack
Outputs a pitch CV when a key is pressed on the ARP 3620 keyboard. If two
keys are pressed, the pitch CV of the higher key is output.
Tip:
The UPPER VOICE output voltage of the ARP 3620 keyboard unit is the same
as the output voltage of this KBD CV-2 jack.
Tip:
For details on the pitch CV voltage when multiple keys are pressed, refer to
“Voice assign mode settings” on page 23.
c. MULTIPLE jacks
These are general-purpose signal distribution jacks (paralleled) that can be used
for either audio signals or control signals.
d. Internal speaker L
e. LEFT SPEAKER slider
Adjusts the volume of internal speaker L.
SPEAKER section R
f. RIGHT SPEAKER slider
Adjusts the volume of internal speaker R.
g. Internal speaker R
h. Power switch
This turns the power on/off.
i. STEREO PHONES jack
Connect your headphones here. This is a φ6.3 mm (1/4") stereo phone jack.