User Manual

ARP 2600 FS
- 14 -
Front panel
(NOISE GENERATOR, VOLTAGE PROCESSORS section)
INITIAL OSCILLATOR FREQUENCY INITIAL OSCILLATOR FREQUENCY
a b c
e
f
d
j
g
h
i
l
m
q
p
n
o
k
NOISE GENERATOR
a. Noise color slider
...........[LOW FREQ...PINK...WHITE]
Adjusts the frequency components
of the noise.
b. Noise level slider
Adjusts the signal level of the noise
generator.
c. NOISE GEN OUTPUT jack
This is the output jack of the noise
generator.
VOLTAGE PROCESSORS
d. Inverter input 1 jack
This is an input jack for an inverter
(a module that inverts a voltage).
e. Inverter input 2 jack
This is an input jack for an inverter.
−10 V is internally connected.
f. Inverter input 2 level slider
Adjusts the voltage level of the
inverter input 2 jack.
g. Inverter input 3 jack
This is an input jack for an inverter.
h. Inverter input 4 jack
This is an input jack for an inverter.
KBD CV is internally connected.
Tip:
If you patch an inverted KBD CV
to a VCO, the relationship between
the keyboard and the pitch is
reversed.
i. Inverter input 4 level slider
Adjusts the voltage level of the
inverter input 4 jack.
j. Inverter output 1 jack
Outputs an inverted summed
voltage of inverter inputs 1–4.
k. Inverter input 5 jack
This is an input jack for an inverter.
l. Inverter input 6 jack
This is an input jack for an inverter.
+10 V is internally connected.
m. Inverter input 6 level slider
Adjusts the voltage level of the
inverter input 6 jack.
n. Inverter output 2 jack
Outputs an inverted summed
voltage of inverter inputs 5 and 6.
o. LAG input jack
This is an input jack for the lag
(delay) circuit. The output of the
envelope follower (see “ENVELOPE
FOLLOWER” on page 6) is
internally connected.
p. LAG TIME slider
Adjusts the length of lag time.
Sliding this toward the right
smooths the output signal.
q. LAG output jack
Outputs a signal smoothed by the
lag circuit.