User Manual
Table Of Contents
- Cover
- English
- Table of Contents
- Introduction to the ARP 2600 FS
- Block diagram
- Panel description and functions
- Front panel (PREAMPLIFIER, ENVELOPE FOLLOWER, RING MODULATOR section)
- Front panel (VCO-1 section)
- Front panel (VCO-2 section)
- Front panel (VCO-3 section)
- Front panel (VCF section)
- Front panel (ADSR EG/AR EG section)
- Front panel (VCA section)
- Front panel (MIXER, REVERB section)
- Front panel (NOISE GENERATOR, VOLTAGE PROCESSORS section)
- Front panel (SAMPLE & HOLD section)
- Front panel (SPEAKER section L, SPEAKER section R)
- Side panel L (MIDI, USB, MODE SWITCH) Side panel R (power, main output jacks)
- ARP3620 keyboard unit
- Getting started
- Let’s make some sounds
- About MIDI
- Troubleshooting
- Specifications
- Français
- Sommaire
- Un mot à propos de l’ARP 2600 FS
- Schéma de principe
- Description des panneaux et fonctions
- Panneau avant (section PREAMPLIFIER, ENVELOPE FOLLOWER, RING MODULATOR)
- Panneau avant (section VCO-1)
- Panneau avant (section VCO-2)
- Panneau avant (section VCO-3)
- Panneau avant (section VCF)
- Panneau avant (section ADSR EG/AR EG)
- Panneau avant (section VCA)
- Panneau avant (section MIXER, REVERB)
- Panneau avant (section NOISE GENERATOR, VOLTAGE PROCESSORS)
- Panneau avant (section SAMPLE & HOLD)
- Panneau avant (section SPEAKER L, section SPEAKER R)
- Panneau latéral G (MIDI, USB, MODE SWITCH) Panneau latéral D (alimentation, prises de sortie principale)
- Clavier ARP3620
- Préparations
- Production de sons
- À propos de MIDI
- Dépannage
- Fiche technique
- Deutsch
- Inhalt
- Einleitung zum ARP 2600 FS
- Blockschaltbild
- Funktionen und Regler
- Oberseite (Sektionen PREAMPLIFIER, ENVELOPE FOLLOWER, RING MODULATOR)
- Oberseite (VCO 1-Sektion)
- Oberseite (VCO-2-Sektion)
- Oberseite (VCO-3-Sektion)
- Oberseite (VCF Sektion)
- Oberseite (ADSR EG/ AR EG-Sektion)
- Oberseite (VCA Sektion)
- Oberseite (MIXER, REVERB-Sektion)
- Oberseite (NOISE GENERATOR, VOLTAGE PROCESSORS-Sektion)
- Oberseite (SAMPLE & HOLD-Sektion)
- Oberseite (SPEAKER-Sektion L, SPEAKER-Sektion R)
- Seitliches Anschlussfeld L (MIDI, USB, MODE SWITCH) Seitliches Anschlussfeld R (Netzanschluss, Hauptausgangsbuchsen)
- ARP3620 Tastatureinheit
- Vorbereitung
- Erzeugen wir nun ein paar Sounds
- Über MIDI
- Fehlersuche
- Technische Daten
- Español
- Tabla de contenido
- Introducción al ARP 2600 FS
- Diagrama de bloques
- Descripción y funciones de los paneles
- Panel frontal (sección PREAMPLIFIER, ENVELOPE FOLLOWER, RING MODULATOR)
- Panel frontal (sección VCO-1)
- Panel frontal (sección VCO-2)
- Panel frontal (sección VCO-3)
- Panel frontal (sección VCF)
- Panel frontal (sección ADSR EG/AR EG)
- Panel frontal (sección VCA)
- Panel frontal (sección MIXER, REVERB)
- Panel frontal (sección NOISE GENERATOR, VOLTAGE PROCESSORS)
- Panel frontal (sección SAMPLE & HOLD)
- Panel frontal (sección SPEAKER LEFT, sección SPEAKER RIGHT)
- Panel lateral izquierdo (MIDI, USB, MODE SWITCH) Panel lateral derecho (alimentación, jacks de salida principal)
- Unidad de teclado ARP3620
- Primeros pasos
- Creación de sonidos de ejemplo
- Acerca de MIDI
- Solución de problemas
- Especificaciones
- 日本語
- 目次
- はじめに
- ブロック図
- 各部の名称と機能
- フロント・パネル (プリアンプ、エンベロープ・フォロワー、リング・モジュレーター・セクション)
- フロント・パネル (VCO-1セクション)
- フロント・パネル (VCO-2セクション)
- フロント・パネル (VCO-3セクション)
- フロント・パネル(VCFセクション)
- フロント・パネル (ADSR EG/AR EGセクション)
- フロント・パネル (VCAセクション)
- フロント・パネル (MIXER, REVERBセクション)
- フロント・パネル (NOISE GENERATOR, VOLTAGE PROCESSORSセクション)
- フロント・パネル (SAMPLE&HOLDセクション)
- フロント・パネル (スピーカー・セクションL、スピーカー・セクションR)
- サイド・パネルL(MIDI、USB、モード・スイッチ) サイド・パネルR(電源、メイン出力端子)
- ARP 3620鍵盤ユニット
- ARP 3620鍵盤ユニット
- 演奏までの準備
- 音を出してみよう
- MIDIについて
- 故障とお思いになる前に
- 仕 様
- 11 -
Owner’s manual
Front panel (ADSR EG/AR EG section)
INITIAL OSCILLATOR FREQUENCY INITIAL OSCILLATOR FREQUENCY
a
b
c
e
g
m
l
h
d
f
i
j k
ADSR EG (Envelope generator)
a. ATTACK TIME slider
Adjusts the attack time of the ADSR envelope generator.
b. DECAY TIME slider
Adjusts the decay time of the ADSR envelope generator.
c. SUSTAIN VOLTAGE slider
Adjusts the sustain level of the ADSR envelope generator.
d. RELEASE TIME slider
Adjusts the release time of the ADSR envelope generator.
e. Output jack
This is the output jack of the ADSR envelope generator.
AR EG (Envelope generator)
f. ATTACK TIME slider
Adjusts the attack time of the AR envelope generator.
g. RELEASE TIME slider
Adjusts the release time of the AR envelope generator.
h. GATE/TRIG source select switch ...............[S/H GATE, KEYBOARD GATE/TRIG]
Selects whether the GATE/TRIGGER signal is received from S/H GATE or from
the keyboard.
i. GATE input jack
Inputs the gate signal. S/H GATE is internally connected.
j. GATE output jack
Outputs the gate signal of the keyboard.
k. TRIG output jack
Outputs the trigger signal of the keyboard.
l. MANUAL START switch
Pressing this switch generates a gate signal, outputting an ADSR/AR signal.
This is convenient when you want to audition the sound without using the
keyboard.
m. Output jack
This is the output jack of the AR envelope generator.










