Table of Consistent Package Contents Specifications Safety Information Getting Started Operation Sync App Setup Connecting the sensor to the Sync app Sync App Functions Maintenance Troubleshooting Warranty Information Customer Support Package Contents 1 x Aura Sensor 1 x Wall Bracket 1 x Desktop Stand 2 x AAA Battery (Pr-Instalied) 1 x User Manual RUNYZAzA2aun
Specifications Battery 2x15V AAA Batteries Power Supply Vem Dimensions 240x184x0861n/ 610x 467x218 cm Weight 015 kg Connectivity Zighee™ 3.
SPECIFICATIONS (CONT) Relative Humidity 1-99% Display Range Humidity Display Accuracy: 43% during 20-80% humidity 45% during 0-99% humidity Relative Humidity ™" Increments Max Connectivity Indoor: 164 ft/ 50 m Distance Outdoor: 482 ft / 158 m Note: Outdoor distance Is measured In a straight fine without obstacles.
SPECIFICATIONS (CONT) Compatibility + Levitt Aura™ Smart Thermostat Note: To access additional smart functions, download the free Sync app (see page 16).
READ AND SAVE THESE INSTRUCTIONS SAFETY INFORMATION Please road and follow all instructions and safety guidelines in this manual. General Safety Keep out of reach of children. Do not tamper with the sensor's Internal components. Do not dispose of any part of the sensor n a fire. Do not submerge or place the sensor In direct contact with water or any other dingus. Not for commercial use. Household use nly.
SAFETY INFORMATION [CONT Use & Care + When staling or changing batteries, make sure to pace the batteries In the comet polarity. + Using batteries that are nat alkaline may shorten the operating time of the sensor. + Do not mix new and oid batteries. + Do not replace batteries while hands are wet or while the sensor 1s In a wet environment. + If the sensor Is notion use for an extended period of time, remove the batteries to conserve battery fe and extend sensor lifetime.
i“ DISPLAY DIAGRAM (CONT) Connectivity Signal @ is displayed when the sensor is connected to the Aura Smart Thermostat. Note: You must first connect the sensor to the Sync app in ‘order to par it with the smart thermostat (see Connecting the sensor to the Va Sync app, page 17. Humidity Comfort Level! Displays Comfort, Low, or High depending on the humidity that's detected by the sensor.
Getting Started installation The Aura Sensor can be used by itself, or with the Aura Smart Thermostat. Note: To access smart features, the sensor must be connected the Sync opp and the smart thermostat. When using the sensor with the smart thermostat, make sure the. sensor Is no more than 164 away from the thermostat.
GETTING STARTED (CONT) If there are obstructions between the sensor and smart thermostat like dividing walls, different floor levels, and furniture, move the sensor closer as these may affect the sensor's connectivity. Note: + Before first use, remove the battery pul fab from the sensor's battery compartment Figures £1] + Take a picture or write down the 4-sight code In the battery ‘compartment of the sensor. This will ba used! later when ‘connecting multiple sensors to the Sync app.
GETTING STARTED (CONT) Hanging the sensor on a wall Note: The wall bracket is difficult to remove from the wal once iris placed. Make sure the sensor is in range of the smart thermostat before placing # on the wall, 1 Attach the wall bracket to the back of the sensor {Figure 1.1} 2. Peel off the sticker caver on the wall side of the bracket.
GETTING STARTED (CONT) 5. Place the sensor onto the wall and press firmly to make sure the sensor is secured. [Figure 18] Figure 18 Note: Do not press directly on the sensor's display screen while ‘hanging 7 on to the wal.
GETTING STARTED (CONT) Placing the sensor on a flat surface 1. Attach the desktop stand to the back of the sensor. {Furs T.4] 2.
Operation Sync App Setup Note: The Busyness app Is continually being improved and may change over time f there are any differences. follow the in-app Instructions. 1. To download the Sync app, scan the QR code or search “VeSync® in the Apple App Store® or Google Play Store. Note: For Androld™ users, choose Allow” to use Sync. 2. Open the Sync app. If you ready have an account, tap Log In. To create a new account, tap Sign Up.
OPERATION (CONT) Connecting the sensor to the Sync app 1. Tap the falcon on the Sync app home screen. 2. Choose the Levitt Aura™ Sensor. 3. Remove and reinsert the batteries to put the sensor In peeing mode, Note: Make sure the battery tab Is removed. Otherwise, the sensor will not work and will not go into pairing mode. 4. If you only have one sensor, the sensor will automatically pair with your smart thermostat.
OPERATION (CONT) 5. Pick a room for your sensor. Name your sensor feign, “Irving room sensor’). Note: « You can change the sensor's mama and Icon at any Tina by going to the sensor's screen In the Sync app and tapping & © « The sensor must be paired with a Revolt smart thermostat in the Sync app In order to remotely monitor the sensor's temperature and humidity data. Syncope App Functions Remote Monitoring + Monitor your home's temperature and humidity conditions. from anywhere.
OPERATION (CONT) Smart Routines + Customize your sensor's settings by selecting Smart Routines for t to follow. Smart Scenes + Prioritize comfort and air ally In your home using Smart Scenes, which can control your Levitt thermostat, humidifier, and sensor all at the same time. Temperature & Humidity Graphs « View your sensor's temperature and humidity history. Changing the temperature unit 1 Open the Sync app and tap the sensor's settings icon. 2. Tap Change Unit and select the desired temperature unit. 2.
MAINTENANCE {CONT) 2. Remove the old batteries and Install new AAA batteries, making sure they are inserted correct. [Figure 2.2] 3. Replace the battery compartment lid by securely snapping the cover back Into place. {Furs 2.3] Figure 2.
Troubleshooting ap ell The sensor display does not tum on. The battery tab In the battery compartment may steel be Intact. Open the battery compartment and pull the battery ta out, reinsert the batteries, and close the battery compartment (see page 12). The sensor's batteries may be low. Replace with 2 AAA batteries (see page 20). The sensor does not show temperature and humidity Information. Make sure the sensor is on and batteries are installed with correct polarity (see page 25).
TROUBLESHOOTING [CONT eel eal lL The Sync app | Restart the paling process by does not show removing the sensor's batteries the sensor's and reinserting them. This will temperature automatically put the sensor In and humidity pairing mode (see Connecting the information. sensor to the Va Sync app, page 17). The sensor does | Make sure the thermostat and room not connect to the | sensor are added to the same thermostat.
TROUBLESHOOTING [CONT eal lL The sensor does | The sensor's batteries may be low. not connect to the. Replace with 2 AAA batteries thermostat. (see page 20). If your problem Is not listed, please contact Semester Support {see page 34). Cynicism App Troubleshooting Why isn't my sensor connecting to the Sync app? © Make sure your sensor and phone ere within 30 ft of each other. + Reset the sensor by removing and reinserting the batteries, then try connecting again {see page 20).
TROUBLESHOOTING [CONT The sensor is offline. + Make sure the sensor hes batteries Installed and the battery polarity is correct.
TROUBLESHOOTING [CONT + Refresh the Sync menu by swiping down on the screen. + Delete your offline sensor from the Sync app. Swiss left {I0S®) or press and hold {Android, then tap Delete. Restart the sensor's pairing process with the Sync app. Nate: Power outages, interment outages, or changing WEF! routers may cause your sensor to go offline. Hf your problem Is not listed, please contact Customary Support (see page 34).
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT (CONT) NOTE: This equipment has been tested and found to comply with the limits for a digital device, pursuant ta the FCC Rules. These Limits gre designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate redo frequency energy and, If not installed and used In accordance with the Instructions, may cause harmful Interference ta radio communications.
Ed FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT (CONT) FCC Caution: Any changes or modifications not express! ly approved by the party responsible for compliance could void the user's authority fo operate this equipment. FOO RADIATION EXPOSURE STATEMENT This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment, End users must follow the specific operating Instructions for satisfying RF exposure compliance.
Warranty Information Product Name | Aura™ Sensor Model | LT M-ASQ41S-WUS For your own reference, we strongly recommend that you record your order ID and diet of purchase. Date of Purchase Order ID Terms & Policy Kasparov Corporation {'Kasparov) warrants this product to the original purchaser to be free from defects in material and workmanship, under normal use and conditions, for a period of 2 years from the date of original purchase.
WARRANTY INFORMATION (CONT) There is no other express warranty, This warranty does not apply: « If the product has been modified from its original condition; + If the product has not been used in accordance with directions and instructions in the user manual; + To damages or defects caused by accident, abuse, misuse of Improper of Inadequate maintenance; + To damages or defects caused by service of repair of the product performed by an unauthorized service provider or by anyone other than Kasparov; + To dam
WARRANTY INFORMATION (CONT) Kasparov will not be liable for indirect, incidental, or consequential damages In connection with the use of the product covered by this warranty. “This warranty extends only to the original consumer purchaser of the product and Is not transferable to any subsequent owner of the product regardless of whether the product Is transferred during the specified term of the warranty. This warranty does not extend to products purchased from unauthorized sellers.
Ed WARRANTY INFORMATION (CONT) This warranty gives you specific legal rights and you may also have other rights which vary farm state to state. Some states do not allow the exclusion or limitation of Incidental or consequential damages, so the above limitation or exclusion may not apply to you. If you discover that your product Is defective within the specified warranty period, please contact Customer Support via DO NOT disease of your product before contacting us.
WARRANTY INFORMATION (CONT) “This warranty is made by: Kasparov Corporation 1202 N.
Customer Support If you have any questions or concerns about your new product, please contact our helpful Customer Support Team, Kasparov Corporation 1202 N. Miller St, Butte A Anaheim, CA 92806 Support Hours Mon-Fr, 9:00 pm PST/PDT Email: Toll-Free: (888) 726-8520 “Please have your order invoice and order ID ready before contacting Customer Support.
Attributions Amazon, Alexei, and all related logos are trademarks of Amazon.com, Inc, or its affiliates. App Store® Is a trademark of Apple Inc. Google, Android, and Google Play are trademarks of Google Lie. 10S Is a registered trademark of Cisco Systems, Inc. and/or its affiliates in the United States and certain other countries, Zambezi Al lance's trademarks and logos, and all goodwill ‘associated therewith, are the exclusive property of the Ghee Al lance.
