Specifications

Software and accessories for total reliability

in controls and communication

Multifunction I/O is a Sentinel 6 range accessory with which you can associ-

ate the battery operation, by-pass, alarm and battery depleted status reports

with dry contacts (maximum current 8A/250V). The accessory also has an

input which is used to set up the configurable remote on, remote off and

remote on/off functions through the UPSTools software (vers. 1.3.3 or higher).

The functions are provided for UPS with firmware version SWM020-01-16 or higher.

CHARACTERISTICS

• Max. current 8A at 250Vac

• Possibility of configuring the signal-to-contact associations

• Pass-through serial link for PC connection

Multifunction I/O

Multifunction I/O - Serial link / contacts duplexer

The MultiCom 401 is an accessory with which you can connect a UPS to a

Profibus DP network. With this device management and monitoring of the

UPS can be integrated in a control system based on one of the field buses

most widely used in industry for communication between control/automation

systems and distributed I/O.

CHARACTERISTICS

• PROFIBUS DP-V1 Protocol

• Configurable address from 0 to 99

• Profidrive V2 PP05

• Configurable baud rate from 9.6 kBit/s to 12 MBit/s

• Led reporting the communication flow

MultiCom 401

MultiCom 401 - PROFIBUS

The IBM AS/400 has a single-level memory management feature that makes it

compulsory for the system to be shutdown in a controlled and orderly manner.

Without UPS protection an AS/400 is not protected from mains failures.

A momentary loss of power can cause hardware damage, data corruption and

a lengthy reboot period. The AROS AS/400 interface kit allows a UPS to be

connected to the AS/400 to initiate an orderly system shutdown on mains failure.

CHARACTERISTICS

• Compatible with all AS/400 systems

• Supports all the AROS UPS ranges

KIT for AS400 and i-Series - Communication Kit