Specifications

Software and accessories for total reliability

in controls and communication

MultiCom 372 provides a UPS with an additional RS232 serial interface port.

The card has Emergency Power Off (EPO) and Remote Shut Down (RSD)

inputs with terminal connections.

CHARACTERISTICS

• EPO and UPS shutdown interface

• 12Vdc 80mA contact option

MultiCom 372

MultiCom 372 - Serial / ESD port

MultiCom 382 provides a set of relay contacts to provide UPS alarm and sta-

tus indication. The contacts are connected through terminal connections.

Signal contacts include Emergency Power Off (EPO), Remote Shut Down

(RSD), On Battery, On Bypass, Alarm and Low battery. The contacts are

change over or normally open.

CHARACTERISTICS

• Max. 3A current at 250Vac

• Signal contact customisation

MultiCom 382

MultiCom 382 - Contacts / ESD board

Multi I/O has configurable input and output signal contacts to allow UPS

integration with control systems. It can be used to connect two devices to a

single UPS serial communication port. It can also communicate using the

MODBUS/JBUS protocol on RS485 lines.

CHARACTERISTICS

• 8 analog/digital inputs

• 8 relay outputs to monitor UPS and mains status

• It can control two independent RS232/RS485 serial lines to monitor the

UPS and its operating states using the MODBUS/JBUS protocol

• Firmware upgradeable through the serial port

Multi I/O, slot version

Multi I/O, box version

Multi I/O - Protocol converter

The RS232-USB converter allows UPS without a USB port to connect to

Macintosh, Windows and Linux PCs with this type of port.

CHARACTERISTICS

• Compatible with USB 1or 2

• Compatible with Watch&Save 3000

USB Converter

USB Converter - USB serial converter