Specifications

Compensation of the recharge voltage
according to temperature in order to
avoid excessive battery charging currents
and potential overheating problems.
Battery Test in order to detect battery
performance deterioration or failure.
Protection against deep discharges:
during extended low load discharges,
the end-of-discharge voltage is
increased as recommended by battery
manufacturers, to prevent damage to the
battery set.
Ripple Current: recharge current ripple
(residual AC component) is one of the
most common causes of poor battery
performance and reduced operating life.
Flexus, with its high-frequency battery-
charger, produces negligible current
ripple levels and therefore helps to
extend operating life.
Wide voltage range: the rectifier can
operate from a wide input range (up to
40% at half load), reducing battery
usage and helping to extend their
operational life.
Flexus 40kVA
Efficiency
(certified by TÜV)
LOW MANAGEMENT COST
The high performance components and
technology used by Flexus means that
the UPS achieves exceptional
performance and efficiency levels, from a
very small footprint and overall compact
dimensions:
• the lowest footprint in this category,
only 0.26 sq. m. for 20kVA Flexus,
batteries included
• the type of input stage guarantees a
power factor close to 1 and a low
current distortion without the addition
of filters, which can be expensive and
bulky
• output power factor of 0.9 providing
up to 15% more active power than a
traditional UPS and more load
expansion.
HIGH EFFICIENCY
High operating efficiency up to 96,5% in
on-line operation providing a 50% saving
in energy usage per annum compared to
traditional UPS products (92%). This
exceptional performance can lead to a
full initial investment recovery within three
years.
Thanks to the high efficiency
up to 96,5% Flexus saves money
during the operation
53