User Manual

Input gain: allows to increase or decrease the output gain of your soundcard,
and so allow you to adjust your sound rendering.
Effects chain: allows to choose if you want to use the effects chain of your track
or not. For example if you use an effects simulator instead of the Guitar Pro 7
effects, it is preferable to disable it for tuning.
Noise Gate: this setting allows to prevent background sound when your guitar is
plugged in but you are not playing it. To set up this option, you have to slowly
turn the potentiometer up, until you notice that the background sound
disappeared (guitar plugged without playing).
Volume: allows to adjust the output volume of the Line In instrument in the
general mix.
Limiter: allows to prevent the feedback effect by decreasing the volume of
sounds exceeding a certain limit.
Note: you can change the effect chain at any time from the track inspector.
Bare in mind to turn off the Line In option after using it.
Important: to make the best out of the Line In feature and for an optimal use, it
is strongly recommended to use the same soundcard for both the audio input
and the audio output.