Instructions

Items included in the package:
1 - Flashlight
2 - Headband
3 - Plastic holder
4 - Clip
5 - 2 spare O-rings
6 - 18350 Li-Ion battery
7 - Magnet USB charger
8 - User manual
4
x2
5 876
Tiara Magnet USB
Set description
1
3
2
Initial Service
1. 2.
3.
We DO NOT RECOMMEND to leave power sources inside the flashlight for a long storage period, as batteries (especially, non-rechargeable) can
leak for various reasons and damage the inner parts of the flashlight. If you want to keep your flashlight in a stand-by state with batteries in then
use new and high-quality batteries and store the flashlight in acceptable for batteries operational temperature and revise the batteries' state at
least once a month. If you have noticed any signs of batteries' defects then withdraw them from the flashlight and utilize. It is also recommended
to replace discharged batteries with new ones before the storage as the chance of leakage is higher with discharged batteries.
ь Your flashlight can inconsiderably differ from the pictures in the manual.
ь The producer reserves the right to change the package at his own discretion without modifying this manual.
To set/replace batteries:
1. Unscrew the tailcap.
2. Place the batteries with the positive contact (+) facing the
head of the flashlight.
3. Adjust the tailcap and tighten it as far as it can go.
The flashlight is ready for operation.
How to turn on a magnet charger:
Unscrew the tailcap for 1/4 of a circle and turn on a magnet
charger device to the tailcap.
Approximate time for charging a fully discharged battery is 6-8
hours. We recommend using adapters with 1A and higher.
Charger device battery indication:
1. Red color – the charging is going on.
2. Green color – the charging is finished.
3. Red color blinking – unscrew the tailcap for 1/4 for
charging.
1/4
Put in the band in the first clasp.
Put in the band through the slots in the plastic holder
and fix the flashlight. Adjust elastic band to the size
of your head.
1.
3.
Pass the end of the band through the second clasp and fix it.
2.
To use the headmount with the flashlight:
Operation
Click x1
OFF вMain (if last used)
Main
Press & Hold
OFF вFirefly1 вFirefly2
Firefly
ON вTurbo
Turbo вLast mode
Click x2
Turbo
Main1 вMain2
ез
Main3
Press & Hold
In OFF state:
Click: To turn on the last used mode.
Press and hold: To go through 2 Firefly modes (release to select). Keeping button pressed will start cycling through the Main modes.
In ON state:
Click: To turn off the flashlight.
Press and hold: To start cycling through the Main modes.
Double click: To turn on the Turbo mode. The second double click brings back the last used mode.
For comfortable operation you have a convenient momentary access to all the following modes:
Main. Short click from OFF-state activates the Main mode (if
it was the last mode used previously).
Firefly. Press and hold the button in OFF-state to turn on the
desired Firefly mode and then release immediately. Keeping
the button pressed will start cycling through the Main
modes.
Turbo. The mode is activated by double click, when the
flashlight is on. To return to the last mode make double-click
again.
Cycling through the Main modes. In ON-state press and hold
the button (in any mode): the 3 Main modes will start
switching cyclically. Release the button to select the desired
mode. In Turbo mode it starts cycling through the Main
modes.
Automemorizing. After switching off the last used Mode is memorized for quick 1-click access at next switching on.
Lock-out function. Unscrew the tailcap to 1/4 for the protection from accidental switching on.
Low Battery Indication. If the brightness is <25% from the nominal value, the LED flashes 2 times
ONCE (after 30sec from switching on). If you are not sure if it flashed or not switch the flashlight
off and on: in case the battery is low flashes will repeat. Light output decreases to Firefly mode at
critical level.
Active temperature control. The flashlight can quickly heat up in Turbo mode. When the
temperature become +60°C – the brightness decreases by small steps. After cooling-down
(provided that battery voltage is sufficient) the brightness increases to the Turbo mode again.
This stepping goes cyclically to maintain the user's safety and the flashlight's functionality. In
conditions of good air-cooling the flashlight delivers light without stepping down even in Turbo
mode. There are no preset timers for stepping, but real-time active temperature measurements.
Cycling through Modes
Warning
Low Battery Indication
Critical
вFirefly1
вOFF