Manual

INSTALLATION

Wall Sleeve Assembly

Toassemble the wall sleeve, refer to the followinginstruc-

tionsand Figure 1.

1. Slidetop panelover side panels untilretaining clips

are engaged in slottedopenings.

Place side and top assemblydown withthe front

flange against floorand slidebottom panel intoside

panelslip strips untiltabs on bottom panels are locked

inplace.

3. Attach squaring bracesto top and side panels using

existingholes. (Do not remove braces untilwall sleeve

issecured to building.)

Attachthe support angles totop and side panels

usingthe #8 x 318"screwsprovided.Two sets of holes

are providedin thepanels for attaching the support

angles. Use the rowof holes nearest the front of the

sleeveto attach the support anglesfor 1"spacing or

the secondset of holesfor 3-3/4" spacing.

The wall sleeve must be square in opening before

securing sleeve to building. Thisis requiredto

assure the Magic-Pak unitwill slide intothe sleeve.

Caulk all seams where the bottompanel joins to the

side panels includingthefront corners of the bottom

panel and the top of side panel slipjoints. Caulk

sealing is best accomplishedafter the wall sleeve is

assembledbutbefore Ris placed inthe wall opening.

Remainingfinal caulk sealing can be donejust after

the sleeve issecured intothe wall opening, if desired,

to avoidbreakingthe seal duringhandling.

Wall Sleeve Assembly

TopPanel

P/N33021B000

Frontof

RightSide Panel P/N 33024B002-

Squaring

Braces

P/N33048B000

LeftSide Panel P/N 33024B001

Side SupportAngle PIN 33027BG00- 2 Side=

Figure I