MSDS

MATERIAL SAFETY DATA SHEET
I. PRODUCT IDENTIFICATION
Name: Armstrong S-390 Shinekeeper Long-Lasting Floor Polish
Description: Acrylic wax
II. DEPARTMENT OF TRANSPORTATION INFORMATION
Shipping name: Not classified. Hazard Class: N/A. ID #: N/A.
EMERGENCY ONLY CONTACT: CHEM-TEL [phone]
III. HMIS (0=minimal hazard; 4 = severe hazard)
Health = 1 Flammability = 0 Reactivity = 0
IV. PRODUCT CONTENT
This product contains chemicals subject to the reporting
requirements of Section 313 of Title III of the Superfund
Amendment and Reauthorization Act of 1986 and 40 CFR Part
372. All components are on TSCA inventory.
V. HAZARDOUS INGREDIENTS
(Chemical Identity; Common Name) C.A.S. No. % OSHA PEL ACGIH TLV
Dipropylene Glycol Methyl Ether 34590-94-8 3-4 100 ppm 100 ppm
STEL: 150 ppm STEL: 150 ppm
(Skin) (Skin)
VI. PHYSICAL DATA
APPEARANCE AND COLOR: Water white liquid. BOILING
POINT (degrees F): N/K. VAPOR PRESSURE (mm Hg @ 20
degrees C): N/K. VAPOR DENSITY (Air = 1): N/K.
SOLUBILITY IN WATER: N/K. SPECIFIC GRAVITY (H
2
O =
1): N/K. PERCENT VOLATILE BY WEIGHT (30 min. @ 275
degrees F): N/K. EVAPORATION RATE (Butyl Acetate = 1):
N/K. pH: 8.6. VOCs: 187 g/l calculated at 70°F/21°C,
SCAQMD.
VII. FIRE AND EXPLOSION HAZARD DATA
FLASH POINT: N/A. FLAMMABLE RANGE: LEL = N/A; UEL
= N/A. EXTINGUISHING MEDIA: N/A. SPECIAL FIRE
FIGHTING PROCEDURES: None. UNUSUAL FIRE AND
EXPLOSION HAZARDS: None.
VIII. HEALTH HAZARD DATA
PRIMARY ROUTE(S) OF ENTRY: Inhalation and direct
skin/eye contact. TARGET ORGANS: Skin and eyes.
EFFECTS OF OVEREXPOSURE: SKIN AND EYES: Contact
with eyes may cause irritation. Prolonged contact with skin of
undiluted product may cause slight irritation. INHALATION:
Normal end-product use does not present an inhalation
hazard. CARCINOGENICITY: NTP: No. IARC Monographs:
No. OSHA Regulated: No. MEDICAL CONDITIONS
GENERALLY AGGRAVATED BY EXPOSURE: None. FIRST
AID PROCEDURES: SKIN AND EYES: If product gets in
eyes, flush with plenty of water for 15 minutes. If wearing
contact lenses, they must be removed immediately and
flushing continued. Consult a physician. For skin contact,
flush well with water. If spilled on clothing, remove and launder
before wearing again. INHALATION: None required.
INGESTION: Call physician or Poison Control Center.
IX. REACTIVITY DATA
STABILITY: Stable. INCOMPATIBILITY: N/A. HAZARDOUS
DECOMPOSITION PRODUCTS: Normal products of
combustion. HAZARDOUS POLYMERIZATION: Will not
occur.
X. SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR
SPILLED: Mop up, or otherwise pick up product with
absorbing materials. Rinse area with clean, cold water; then
dry. WASTE DISPOSAL METHOD: Do not reuse container.
Dispose of container and any unused contents in accordance
with Federal, State and Local Waste Disposal Regulations. Do
not flush unused contents or residue down drains.
XI. SPECIAL HANDLING AND USE INFORMATION
VENTILATION: Normal ambient ventilation should be
sufficient. RESPIRATORY PROTECTION: Should not be
required. SKIN AND EYE PROTECTION: Avoid contact with
eyes and prolonged contact with skin. If contact may occur,
use spectacle-type glasses and latex or rubber gloves.
XII. SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND
STORAGE: Keep from freezing. OTHER PRECAUTIONS:
None.
The information presented herein is supplied as a guide to those who
handle or use this product. Safe work practices must be employed
when working with any materials. It is important that the end user
makes a determination regarding the adequacy of the safety
procedures employed during the use of this product.
N/A – not applicable or not available
N/K - none known or not known
S-390
Prepared 6/09
Armstrong World Industries, Inc.
P. O. Box 3001
Lancaster, PA 17604
www.armstrong.com
MSDS: www.floorexpert.com
Technical Services:
1-877-276-7876
,
O
p
tion 2
,
3
,
3