Replacement Parts

1050 & 1060 3-PIECE CIRCULATORS
CUSTOM IN-LINE | SUBMITTAL
29
|
HYDRONIC SOLUTIONS CATALOG
Job:
Representative:
Engineer:
Contractor:
Order no: Date:
Submitted by: Date:
Approved by: Date:
materials of construction
part name bronze fitted all bronze
Pump body Cast iron Bronze
Impeller: series 1050: Non–ferrous
series 1060: Bronze
Bearings: Sleeve–oil lubricated
Shaft: Alloy steel–copper sleeve Coupler: Flexible spacer type
Mechanical seal assembly: Carbon/SiC, stainless steel trim, Viton seal
ma ximum pump oper ating cond itions
175 psig at 225°f (1207 kPa at 107°c)
pump design data
Pump model: Flange size:
No. of pumps:
Note:
Capacity:
USgpm (L/s) Temperature: °f (°c)
Head:
ft (m) Liquid:
Companion flanges: Included
The pump should be installed in a
position to permit proper lubrication
of bearings and servicing. Motor and
bearing bracket are to be kept free of
insulation. Pump and motor unit are
designed to be supported by the in line
piping only. Do not support in any other
manner. A height of approximately 4
feet above floor is recommended.
mounting orientation
motor design data
kW: rpm: 1800 Hertz:
Frame size: Enclosure:
horizontal mounting
back to
contents
<