Replacement Parts
Table Of Contents
- commercial & residential pumps
- Design Envelope Compass Circulators
- Astro 2 Circulators
- Astro 2 Hot Water Recirculation Systems
- Astro 2 24-hour timer
- Aquastat controls
- Astro Express 2 Hot Water Recirculation
- S&H 3-Piece Circulators
- 1050 & 1060 3-Piece Circulators
- E.2 Circulators
- E.2 Circulator Spool Pieces
- 4270 & 4270 Stock Motor Mounted Pumps
- 4360 Pump-in-a-Box
- 4380 Pump-in-a-Box
- Design Envelope 4300/4380 Pump-in-a-Box
- hydronic specialties
- circuit balancing valves (cbv)
- replacement parts
- parts look up
- competition circulator cross reference
- technical data
- Pump Formulas
- Pressures & Altitudes
- Freezing & Boiling Points
- Ethylene Glycol Properties
- Propylene Glycol Properties
- Water Properties
- Useful System Curve Formulas
- Pipe Maximum Pressures
- Hydraulic Resistance
- Pipe Information
- Pipe Fittings & Valves Friction Loss
- Water Flow Calculator
- Unit Conversions
- Typical Symbols
- Product Solution Outlines/Brochures
ASTRO 2
|
HOT WATER RE-CIRCULATION SYSTEMS
SUBMITTAL
11
|
HYDRONIC SOLUTIONS CATALOG
Power connection: 6.0 ft. (1.8 m) power cord, molded duplex
plug with ground
Environment: Indoor use only
Flow range: 0 to 64 USgpm (0 to 4.04 L/s)
Head range: 0 to 42.0 feet (0 to 12.8 m)
Max. working pressure: 150 psi (1034 kPa)
Max. water temperature: 230°f (110°c)
†
Ambient temperature: 39°f (4°c) to 104°f (40°c)
Low temperature switchpoint
1
: 85°f (29°c) ± 10%
High temperature switchpoint
1
: 105°f (40°c) ± 10%
Clock/timer: 12 hour analog clock with am/pm indication
Timer settings: Individual mechanical toggles for each 15
minute interval over 24 hours
Manual override: Three position slide switch; on/auto/o
Approvals: listed certified
Job:
Representative:
Engineer:
Contractor:
Order no: Date:
Submitted by: Date:
Approved by: Date:
materials of construction
* Certified <0.25 weighted average percent lead and complies with California
Health and Safety Code Section 116875 (commonly known as ab 1953).
Pump body: Lead free bronze* (bs models)
Stainless steel* (ss models)
Impeller: Noryl
Shaft: Ceramic
Bearings: Ceramic Gasket material: epdm
1 High/low temperature switchpoints are as measured on pipe surface with the
Aquastat (ta models only).
†
For open systems, it is recommended that the fluid temperature be less
than 150°f (66°c) to avoid precipitation of calcium.
technical data
pump design data
Pump model: Flange size:
No. of pumps:
Note:
Capacity:
USgpm (L/s) Temperature: °f (°c)
Head:
ft (m) Liquid:
Companion flanges: Included:
application
Armstrong Astro 2 hot water re-circulation systems
automatically circulate water through domestic hot water
distribution pipes. This helps to ensure that everyone in the
household has ‘instant’ hot water at the tap when they need
it, while also helping to conserve water and save water heat-
ing energy costs. All systems are assembled, wired, tested
and then shipped, ready for installation.
mounting orientation
model
electrical
input
speed
full load
amp
draw (a)
nominal
power (w)
astro
220ssu
115v, 60hz
Single phase
3 0.29
33
2 0.27
1 0.20
astro
225bs
3 0.64
752 0.49
1 0.38
astro
225ssu
3 0.69
832 0.55
1 0.43
astro
230ss
3 0.81
972 0.58
1 0.45
astro
250ss
3 0.98
117
2 0.79
1 0.65
motor data
right wrong
back to
contents
<