Technical Specifications

chance to set up over porous surfaces.

 Note: Allowing the proper open time will help to minimize knee marks, roller marks and trapped

air blisters. Open time will vary based on job conditions, substrate, temperature, air flow and

humidity.

 Roll thoroughly. Starting at the center and working toward the edges, roll in two directions using a

100-lb roller. Seams must be hand rolled, then rolled again with a 100-lb roller.

 Remove wet adhesive residue using a clean, white cloth dampened with soapy water. Use

mineral spirits for dried adhesive residue carefully following warnings on container.

Protect newly installed flooring when moving heavy appliances and/or rolling loads.

LEED / Environmental

LEED Credits: EQ 4.1

Sustainable Design Information Sheet

LEED Credit Information - Installation Products

Warranty

When Armstrong S-288 is used with a recommended Armstrong floor application, the Armstrong Guaranteed Installation

System warranty applies.

Product Image