Installation Guide

5
Armstrong S-500 Seam Coater/Application
 When using the S-500 Seam Coater Kit make sure flooring is installed, seam area has been
hand rolled and the entire floor rolled with a 100 lb roller. Then apply the seam coater as
directed on package.
6. Finish the Job
 Replace or install baseboard moldings or coved wall base to cover expansion zone (gap) around
perimeter of room. Fasten molding to vertical surface; do not nail through new floor or into
expansion zone.
 Leave a slight clearance between molding and flooring so any effects of seasonal movements
in your home due to temperature or humidity changes will be minimized. Should a small
bubble or buckle occur, the flooring should be gently lifted or pulled back from the pinch point
and retrimmed.
 At doorways where new flooring meets another floor surface, use a trim molding that covers the
edges of the floor. This is the preferred method of installation.
.
Precautions for All Installation Options:
 Do not wash or scrub the new flooring for at least 5 days after the installation. This will help
prevent excess moisture and cleaning agents from interfering with the bond of the fresh adhesive
or vinyl flooring tape.
 When moving appliances or heavy furniture, lay a plywood panel on the floor and “walk” the item
across it. This protects the floor from scuffing and tears.
 Use floor protectors, such as Armstrong Floor Protectors, on furniture to reduce indentation. The
heavier the item, the wider the floor protector needed.
NA-5917-915