SDS

Armstrong World Industries
2500 Columbia Ave.
Lancaster, PA USA 17603
Armstrong S-495 Commercial Floor Sealer Telephone: [phone]
04-Mar-2015 Page 3 of 7
Personal precautions : Restrict access to area until completion of clean-up. All persons dealing with
clean-up should wear the appropriate chemically protective equipment.
Protective equipment : Refer to Section 8 on this Safety Data Sheet, EXPOSURE CONTROLS /
PERSONAL PROTECTION, for additional information on acceptable personal
protective equipment.
Emergency Procedures : If a spill/release in excess of the EPA reportable quantity is made into the
environment, immediately notify the national response center in the United States
(phone: [phone]).
US CERCLA Reportable quantity (RQ): None reported.
Methods and materials for containment and cleaning up
: Ventilate area of release. Eliminate all ignition sources. Stop spill or leak at source
if safely possible. Contain product with inert absorbent material, preventing it from
entering sewer lines or waterways. Gather up spilled material and place in suitable
container for later disposal (see Section 13).
Residual of product, while still wet,
can be cleaned up with warm soapy water. Notify the appropriate authorities as
required.
Prohibited materials : None known.
Environmental precautions : Do not allow product to enter drains or waterways. Do not allow material to
contaminate ground water system.
Reference to other sections : See Section 14 for disposal information.
Safe handling procedures : Wear suitable protective equipment during handling. (See Section 8.) Observe
good hygiene standards. Use only with adequate ventilation. Wash thoroughly after
handling. Avoid contact with eyes, skin, or clothing. Avoid repeated or prolonged
skin contact. Avoid breathing vapors or mists of this product. Wear protective
clothing to prevent skin contact. Promptly remove any clothing that becomes
contaminated. Clean contaminated clothing before reuse. Keep container tightly
closed.
Storage requirements : Store in a cool, dry, well-ventilated area. Store away from heat and open flame.
Avoid storing in direct sunlight. Store in original container. Keep tightly closed when
not in use. Do not reuse empty container without commercial cleaning or
reconditioning.
Incompatible materials : See Section 10.
Special packaging materials :
Always keep in containers made of the same materials as the supply container.
Permissible Exposure Limits : No exposure limits have been established for the product itself. Below are exposure
limits for the components in the product.
Ingredients
CAS #
ACGIH TLV
TWA STEL
OSHA PEL
PEL STEL
2-(2-Butoxyethoxy)ethanol
112-34-5
N/Av N/Av
N/Av N/Av
Diethylene glycol monoethyl ether
111-90-0
25 ppm N/Av
WEEL USA
N/Av N/Av
Tris(2-butoxyethyl) phosphate
78-51-3
N/Av N/Av
N/Av N/Av
Engineering Controls :
Use general or local exhaust ventilation to maintain air concentrations below
recommended exposure limits. Ventilation should effectively remove and prevent
buildup of any vapor generated from the handling of this product.
Personal Protection Equipment
Eye / face protection :
Chemical goggles or safety glasses, as appropriate for the job.
SECTION 7 – HANDLING AND STORAGE
SECTION 8 – EXPOSURE CONTROLS AND PERSONAL PROTECTION