Use and Care Manual

Disinfecting Guidelines:

Armstrong

Ceiling and Grid Products

Disinfectant Methods

FOG

• Use the equipment manufacturer’s instructions regarding distance from the surface, protective gear, and ventilation.

• If another cleaner has been used in the fogging equipment, be sure to thoroughly clean the equipment before use

to avoid potential contamination of the board surface with a non-compatible or staining cleaner.

• Remove any obvious dirt before evenly applying cleaner.

• Wipe dry with a clean, white microfiber cloth. Alternatively, the board may be air dried.

SPRAY

• Remove any obvious dirt before applying liquid cleaner.

• Use the concentration of the cleaner as provided in table above.

• Spray the recommended disinfectant evenly over the board surface.

• Wipe with a dry, white microfiber cloth ater recommended dwell time (typically 10 minutes).

WIPE

• Remove any obvious dirt before applying liquid cleaner.

• Use the concentration of the cleaner as provided in the table above.

• Apply cleaner to a sponge or cleaning cloth. Squeeze out excess liquid until the sponge or cloth is damp.

• Gently and evenly wipe the cleaner across the board surface with the damp sponge or cloth. Use even strokes, up to

5 passes across a single position along the surface. Do not exceed the time of exposure recommended by the cleaner

manufacturer (typically 10 minutes).

• Wipe with a clean, white microfiber cloth to remove excess liquid.

• Allow the board to finish drying.

NOTE: If liquid is not removed, it may stain the board surface over time.

Disclaimer

Cleaning conditions and aesthetics may be impacted by additional site conditions. These instructions pertain only to the maintenance of the

aesthetics and integrity of Armstrong Ceilings products. Please consult the manufacturer’s instructions and guidance regarding any cleaning

product or disinfectant product for use and eficacy.

RC--

ceilings.com

Morning Mist

™

is a trademark of Diversey, Inc.

ShockWave

™

and the ShockWave

™

Logo are trademarks of Fiberlock Technologies, Inc.

All other trademarks used herein are the property of AWI Licensing LLC and/or its afiliates