User's Manual

08 | OPERATING INSTRUCTIONS
Your new pump action shotgun is packed dismounted in its box, i.e. barrel is
separated from the stock-receiver-forearm assembly. To attach the barrel, first
remove all parts from the plastic bags. Before proceeding with the assembly of the
shotgun, carefully check the “Nomenclature” and read “Safety Measures” section.
ASSEMBLY INSTRUCTIONS
Assemble the shotgun as follows:
• Unscrew the magazine cap (counter-clockwise) and remove it form the magazine tube. (3)
• Insert the barrel extension into the receiver. While doing this, be sure the barrel seats between the bolt and the receiver and barrel port ring is aligned with the magazine
tube. Continue to slide the barrel into the receiver until the barrel seats completely inside the receiver. (4)
• Screw the magazine cap (clockwise) so that the forearm and barrel are held properly in place. The shotgun is now assembled and ready to use.
Migratory magazine plug when assembled decreses the capacity of the shotgun to 2+1 for safety reasons or for the regulations varying from country to country.
PS. Migratory magazine plug is optional. Consult your dealer about your country’s laws regarding use of this
It is recommended to have you migratory magazine plug assembled by a qualified gunsmith.
Assemble the migratory magazine plug as follows:
• Unscrew the magazine cap.
• Insert the polymer rod, making sure the head is centered in the end of the magazine tube.
• Replace the magazine cap. To remove the plug, reverese the procedure above.
NOTE:
To disassemble the shotgun, reverse the above assembly procedure. To
disassemble the bolt; slide the bolt and the action bar forward and remove
them from the magazine tube-receiver assembly after the barrel is
removed. While doing this, be careful since the bolt may fall from the
action bar. Therefore keep the bolt up during this operation. Then the bolt
can be easily removed from the action bar with you hand.
MIGRATORY MAGAZINE PLUG
WARNING:
BEFORE ASSEMBLING THE SHOTGUN, CHECK THE BARREL. BORE AND CARTRIDGE CHAMBER MUST BE
CLEAN AND THERE SHOULD NO OBSTRUCTIONS IN THEM.
WARNING:
IF
1. BOLT DOES NOT SLIDE FORWARD.
2. THERE IS A GAP BETWEEN FOREND AND RECEIVER.
3. BARREL PROTURES FROM THE RECEIVER, THAT MEANS YOU HAVE NOT ASSEMBLED THE SHOTGUN
PROPERLY. IN SUCH A CASE, IMMEDIATELY REVERSE ASSEMBLY PROCEDURES AND RE-ASSEMBLE
YOUR SHOTGUN MAKING SURE THAT THE BARREL IS COMPLETELY INSERTED INTO THE RECEIVER,
FOREND IS COMPLETELY IN PLACE AND THERE ARE NO GAPS. IF YOU STILL CANNOT ASSEMBLY THE
SHOTGUN PROPERLY TAKE IT TO A QUALIFIED GUNSMITH FOR HELP.
**AFTER YOU ASSEMBLED YOUR SHOTGUN OR IF YOU ARE TAKING IT TO A GUNSMITH FOR HELP, MAKE
SURE THAT YOU KEEP THE SAFETY “ON”.