User's Manual

06 | OPERATING INSTRUCTIONS
ASSEMBLY
Make sure there are no shells in the chamber.
1. Remove all dirt and excess oil from gun, especially from the breech area, also barrel
interior and ends.
2. Remove the forearm by pushing the forehand iron catch upwards, this allows the nose
of the forearm to release. With your other hand and at the same time you are pushing the
iron catch release upwards, separate the forearm from the barrel (Photo 1).
3. Lightly oil the already cleaned contact points. Attach barrels to action by grasping the
grip of the stock with your right hand and placing the stock under your right arm. With your
right thumb move the opening lever to the right. Now hold the barrels with your free hand
and slide the barrels through the top of the receiver, with the barrel’s nose pointing down
until the hinge notch engages with the hinge pins (Photo 2).
4. Keeping the hinge pin notch engaged with the hinge pin, lift the nose of the barrels
until the action closes.
Caution: If you attempt to close the gun and the barrels bind or don’t seem to fit then the
hinge pin and notch are not engaged. DO NOT FORCE, try again. Release the hinge pin
and notch and the barrels will be locked in place.
5. Replace the forearm on the gun by sliding the rear of the forearm into the barrel at the
same angle by which your removed it. The round rear of the forearm should match the
round front of the receiver. Lift the nose of the forearm until it engages with the barrels
with an audible “click.” If the forearm release latch protrudes after the “click,” gently push
it in place. (Photo 3)