User's Manual

08 | OPERATING INSTRUCTIONS
To unload your rifle, you must first detach magazine
box from the rifle. Then, the chamber of the rifle can
be cleared by holding the bolt handle and pulling it
fully rearward (bolt open) and let it snap forward
freely. This must be done repeatedly until the
chamber is free of any cartridge.
(A) MISFIRE: Once you have squeezed the trigger and nothing happens, remain in shooting position
pointing the gun in safe direction. Wait for 10 seconds, then clear the action.
(B) UNDER POWERED SHOT: An UNDER POWERED SHOT should not occur if the ammunition is clean,
dry and factory loaded. You can tell if a shot is under powered by the unusually low report it makes.
TO UNLOAD RIFLE
(WITHOUT FIRING)
IF RIFLE FAILS TO FIRE:
Your rifle has been sighted and test-fired at the factory. However, due to individual shooting
characteristics, sighting should be range-verified.
(A) HORIZONTAL CORRECTION: To move the point of impact to the left, move the rear sight block to the
left. This can be accomplished by loosening the left side rear sight block screw & tightening the right side
rear sight block screw. To move the point of impact to the right, move the rear sight block to the right. This
can be accomplished by loosening & tightening (in small increment) the right side & left side rear sight
block screw, respectively.
(B) VERTICAL CORRECTION: To raise the center of impact, move the rear sight elevator ring forward, in
one position at a time. To lower the center of impact, move the rear sight elevator ring rearward.
SIGHTS ADJUSTMENT
YOU MUST EXAMINE VISUALLY THE CHAMBER BREECH AREA TO BE SURE THAT NO
CARTRIDGE REMAINS. VISUAL CHECK MAY BE ACCOMPLISHED BY PLACING THE
BOLT INTO BOLT-OPEN POSITION. PLACING THE BOLT IN OPEN POSITION IS DONE
BY PULLING THE BOLT HANDLE REARWARD TO A DISTANCE JUST ABOVE THE
LOCATION OF SAFETY LEVER SQUARE NOTCH. HOLD IT IN THAT POSITION AND
SWING UP THE SAFETY LEVER, LETTING THE SQUARE NOTCH CATCH THE BOLT
HANDLE. YOU CAN NO VISUALLY EXAMINE THE CHAMBER BREECH AREA.
THE BULLY MAY STILL BE IN THE BARREL WHEN UNDER POWERED SHOT IS FIRED,
YOU MUST UNLOAD COMPLETELY, CLEAR THE ACTION, AND LOOK THROUGH THE
BARREL TO SEE IF THERE IS ANY OBSTRUCTION. IF THERE IS, IT SHOULD BE
REMOVED BY USING 3/16” DIAMETER BRASS ROD.
CAUTION: