Manual

TO MAKE GUN SAFE: Safety lever is at the right side of the receiver and at the back
of the bolt operating handle. Pull safety latch toward the “S” mark on the receiver. This
locks trigger and gun cannot be fired.
TO LOAD CHAMBER: With the safety on, insert a loaded magazine into the rifle. Pull
the bolt operating handle all the way to the rear and release, allowing the bolt to move
forward under full force of the operating springs. Bolt automatically picks up a cartridge
from the magazine and feeds it into the chamber. Do not ease bolt forward.
TO FIRE: Be sure gun is pointed at safe target. Release safety and pull the trigger.
Pressure from the burning powder opens up bolt, ejects empty shell, and reloads the
chamber for the next shot. Pull the trigger again. Gun fires as fast as trigger is pulled
until magazine is empty.
TO UNLOAD WITHOUT FIRING: Draw safety on and release the magazine from
guard. Work action several times to remove any cartridge left inside the chamber. Slide
bolt handle rearward and lock piece. Inspect the chamber to make sure no cartridge is
left. Empty magazine can be placed back if desired.
1. DISASSEMBLY
A. STOCK AND TRIGGER GUARD HOUSING
1. Remove the magazine by depressing the magazine catch.
2. Remove front screw of the trigger guard housing and detach barrel-receiver
assembly from the stock.
B. TRIGGER GROUP
1. Trigger housing may be disassembled by unscrewing the two hold down
screws. (This step is not advisable unless necessary)
2. Remove the trigger by punching out trigger stop pin and pivot pin.
3. Remove the trigger spring and spring follower at the end of the housing.
C. BOLT DISASSEMBLY
Page 2 of 9