Manual

ManualsBrandsArmscor ManualsFirearms30

ARMSCOR

MODEL 30 SHOTGUN

USER’S MANUAL

WARNING:

READ THE INSTRUCTIONS AND SAFETY PRECAUTIONS IN THIS

MANUAL CAREFULLY BEFORE USING THIS FIREARM.

DISCHARGING FIREARMS IN POORLY VENTILATED REAS, CLEANING

FIREARMS OR HANDLING AMMUNITION MAY RESULT IN EXPOSURE

TO LEAD AND OTHER SUSTANCES KNOWN TO THE STATE OF

CALIFORNIA TO CAUSE BIRTH DEFECTS, REPRODUCTIVE HARM AND

OTHER SERIOUS PHYSICAL INJURY. HAVE ADEQUATE VENTILATION

AT ALL TIMES. WASH YOUR HANDS THOROUGHLY AFTER

EXPOSURE.

OPERATING INSTRUCTION

TO MAKE GUN SAFE

With hammer cocked, push safety button from left to right until red band is covered

(Note: Safety button is in trigger guard bow). This locks trigger and gun cannot be

fired. Always lock trigger when gun is loaded.

TO RELEASE SAFETY

Push safety button from right to left exposing red band. Gun is ready to fire.

Page 1 of 8

Summary of content (8 pages)

PAGE 1
ARMSCOR MODEL 30 SHOTGUN USER’S MANUAL WARNING: READ THE INSTRUCTIONS AND SAFETY PRECAUTIONS IN THIS MANUAL CAREFULLY BEFORE USING THIS FIREARM. DISCHARGING FIREARMS IN POORLY VENTILATED REAS, CLEANING FIREARMS OR HANDLING AMMUNITION MAY RESULT IN EXPOSURE TO LEAD AND OTHER SUSTANCES KNOWN TO THE STATE OF CALIFORNIA TO CAUSE BIRTH DEFECTS, REPRODUCTIVE HARM AND OTHER SERIOUS PHYSICAL INJURY. HAVE ADEQUATE VENTILATION AT ALL TIMES. WASH YOUR HANDS THOROUGHLY AFTER EXPOSURE.
PAGE 2
TO LOAD CHAMBER Open action fully by pulling back the forearm up to rear position. If gun is locked, press action slide release lever located on rear left side of trigger guard bow. Insert shell directly into chamber and push forearm forward to close action. TO LOAD MAGAZINE TUBE With trigger locked, insert shell upward into bottom of receiver and push forward into magazine tube past cartridge stops. Repeat until magazine tube is full. TO OPERATE When gun is fired, action automatically unlocks.
PAGE 3
ACTION SLIDE. Move forearm backward until shoulders of slide are centered in the square cuts of receiver. Pull action slide upward then fully move forearm forward to free action slide from action slide bar. Now lift the action slide out of the receiver. CARRIER AND BREECH BOLT Lift the carrier-front end and slide bolt forward. Pressed the two legs of carrier inward to disengage buttons from receiver hole and pull out carrier.
PAGE 4
ACTION SAFETY BUTTON Farther disassembly of the Trigger Guard Safety Button is not recommended for routine cleaning. These procedures serve as a guide only for qualified gunsmith. 1. Lay down the gun with trigger guard up. Cock the gun. Push safety button to expose red band then change the position of the gun right side-up 2. Using long-nose pliers grip tightly the end portion of safety and rotate safety button 90 degrees clockwise so that plunger is freed from the notch of the safety button.
PAGE 5
PRODUCT SPECIFICATION Gauge 12 Ga. Magnum Chamber 3.00 inches Action Pump Action Magazine Capacity 7+1 Barrel Length 20.00 inches Overall Length 40.00 inches Length of Pull 13 ½ to 13 ¾ inches Drop at Heel 2 ½ to 2 5/8 inches Drop at Comb 1 ½ to 1 5/8 inches Weight 7.00 pounds Finish Blued Stock Polymer Forearm & Butt stock without Ammo Pouch Other Precision Reamed and Chambered Ordnance Steel Barrel, Cross-Bolt Safety and Damascened Bolt.
PAGE 6
Bullet Carrier 3009A Bullet Carrier Button 3009B Carrier Operating Cam 3010 Carrier Operating Cam Pin 3011 Cartridge Stop Left 3012A Cartridge Stop Right 30M13 Cartridge Stop Pin 3014 Cartridge Stop Spring 3015 Ejector 30M16 Ejector Spring 3017 Extractor 3018 Extractor Hinge Pin 3019 Extractor Spring 3020 Firing Pin 30M21 Firing Pin Retainer Pin 3022 Firing Pin Spring 3023 Forehand Operating Handle 3024 Action Slide Bar 30M25 Action Slide Bar Left 30M25A Action Bar Reta
PAGE 7
Hammer Spring Retainer Pin 3034 Magazine Band 3035 Magazine Band Screw 3036 Magazine Cap 3037 Magazine Spring 3038 Magazine Spring Follower 3039 Magazine Tube 3040A Magazine Ring 3040B Magazine Tube Lock Screw 3041 Stock Bolt 3042 Safety Button 3043 Safety Plunger 3044 Safety Plunger Spring 3045 Stock Bolt Nut 3046 Stock Bolt Washer 3047 Stock Bolt Lock Washer 3048 Trigger 3052 Trigger Guard 3053 Trigger Guard Retainer Pin 3054 Trigger Guard Retainer Pin Spring 3055 T
PAGE 8
Page 8 of 8