User's Manual

WWW.WARSENSOR.COM
WARSENSOR WSF User Manual
Revision 1 printed 8/16/2005
Mail: [e-mail]
10
Section 2
-Cocking Marker
-Applying air source
-Leaks
Warning: The power system used on the Warsensor Field Marker contains HPA/CO2/N2. Never work on or
disassemble the marker with compressed air source connected. This marker has a volumizer chamber which will
retain pressure. Please make sure your marker is properly clear of all compression before disassembly.
If working with CO2, avoid CO2 gas or escaping liquid to contact the skin, this will cause freezer burn on the
contacted skin.
Always insure your power source bottle is firmly screwed in to avoid accidental release which can cause bodily
harm.
Power Source options for WSF
Before attaching any power source to your marker, search for different power source options. This
marker is factory configured to use an air source attached directly to the bottom-line, but other options
are available.
To run the power source off of the
bottom-line.
Attach the bottle to the bottom-line asa.
You may also run a remote from the bottom-line
asa. If you run a remote, a remote nipple
must be attached to the asa.