Specification

!
!
!
ArmorPoxy High Build Epoxy - Part B!
_____________________________________________________________________________________________!
6. Accidental Release Measures!
!
6.1 Personal precautions, protective equipment and emergency procedures!
!
Stop leak if you can do it without risk. ELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area).
Ensure adequate ventilation, especially in confined areas. Take precautionary measures against static discharges. Avoid contact
with skin, eyes and inhalation of vapors. Refer to protective measures listed in sections 7 and 8.!
!
6.2 Environmental precautions!
!
Prevent further leakage or spillage if safe to do so. Prevent product from entering drains. Do not allow material to contaminate
ground water system. See Section 12 for additional Ecological information.!
!
6.3 Methods and materials for containment and cleaning up!
!
Methods for Containment!
Dike to collect large liquid spills. Prevent further leakage or spillage if safe to do so. Contain
and collect spillage with non-combustible absorbent material, (e.g. sand, earth,
diatomaceous earth, vermiculite) and place in container for disposal according to local /
national regulations (see Section 13). Prevent material from entering surface waters, drains
or sewers, and soil. Spills of material which could reach surface waters must be reported to
the United States Coast Guard National Response Center's toll free phone number (800)
424-8802.!
!
Methods for cleaning up!
Use a non-combustible material like vermiculite, sand or earth to soak up the product and
place into a container for later disposal. Use clean non-sparking tools to collect absorbed
material. Keep in suitable and closed containers for disposal.!
!
7. Handling and storage!
!
7.1 Precautions for safe handling
Advice on safe handling!
!
!
Keep away from open flames, hot surfaces and sources of ignition. Take necessary action
to avoid static electricity discharge (which might cause ignition of organic vapors). Use only
in well-ventilated areas. Do not eat, drink or smoke when using this product. Empty
containers may retain product residue or vapor. Ensure adequate ventilation. Handle in
accordance with good industrial hygiene and safety practice. Wash thoroughly after
handling.!
!
Hygiene measures! Handle in accordance with good industrial hygiene and safety practice.!
!
7.2 Conditions for safe storage, including any incompatibilities!
!
Storage Conditions!
Keep away from heat and sources of ignition. Keep containers tightly closed in a cool,
well-ventilated place.!
!
Materials to Avoid!
No materials to be especially mentioned.!
!
8. Exposure controls/personal protection!
!
8.1 Exposure Guidelines!
!
ACGIH TLV!
OSHA PEL!
British Columbia!
Alberta!
Quebec!
Ontario TWAEV!
-!
TWA: 15 mg/m3!
total dust
TWA: 5 mg/m3!
respirable fraction!
TWA: 10 mg/m3
TWA: 3 mg/m3!
STEL: 20 mg/m3!
TWA: 10 mg/m3!
TWA: 10 mg/m3!
!
STEL: 150 ppm
TWA: 100 ppm!
TWA: 100 ppm!
TWA: 435 mg/m3!
TWA: 100 ppm
STEL: 150 ppm!
TWA: 100 ppm
TWA: 434 mg/m3
STEL: 150 ppm!
STEL: 651 mg/m3!
TWA: 100 ppm
TWA: 434 mg/m3
STEL: 150 ppm!
STEL: 651 mg/m3!
TWA: 100 ppm
STEL: 150 ppm!
TWA: 20 ppm!
TWA: 100 ppm!
TWA: 300 mg/m3!
TWA: 15 ppm!
Ceiling: 30 ppm!
TWA: 20 ppm!
TWA: 60 mg/m3!
Ceiling: 50 ppm!
Ceiling: 152 mg/m3!
Skin!
TWA: 20 ppm!
!
_____________________________________________________________________________________________!
04-01-2023 - - 1 - AGHS - English -! Page 4 / 11!