Use and Care Manual

BEFORE YOU START
● SUPPLIES You need to supply the following items: standard 9” roller frame, painting extension
pole, and power drill as these items are not included in the kit. Other suggested items are
measuring cups, roller tray (for the topcoat), a plastic or cloth drop cloth to mix on and xylene
or similar cleaner and rags for cleaning hands or drips.
● ETCH ArmorPoxy’s Etch is a mild, powdered citric-based cleaning agent. It is not dangerous,
however it is best practice to always wear protective eyewear, rubber gloves, and keep skin
covered when applying.
● OLDER, STAINED, FIBER REINFORCED OR HIGHLY POLISHED CONCRETE Concrete that has been in
service for extended periods of time, particularly garage floors, becomes polished from the
repeated traffic in the common areas. Also, impurities and chemicals from tires become
trapped in the porous surface. The use of tire shine products like ‘Armorall’ also creates
resistance to most coatings. These conditions may require additional treatment to create a
strong bond for ArmorPoxy’s coatings.
● SURFACE PREP IS THE MOST CRITICAL STEP to assure peak performance of the ArmorTallic epoxy
kit system. It is important to apply the product to a clean, well-prepared surface. The surface
must be free of debris, loose or flaking concrete, dirt, oil, curing compounds, previous
coatings, sealers, and loose paint. Even new concrete must be cleaned to remove dirt, dust,
and salts that form as the concrete cures.
DO NOT SKIP THE PREP STEP. IF FLOOR IS NOT PREPPED FAILURE OR UNEVEN OUTCOME CAN OCCUR.
● SAFETY As with any chemicals, avoid contact with skin, avoid inhalation and wear protective
clothing, rubber gloves and eye protection. Apply only in well-ventilated areas. Follow all local,
state, and federal regulations that may apply to your region. See our website at
www.armorpoxy.com for Safety Data Sheet sheets.
● CLEAN UP Clean up with xylene (xylol) available at any paint or hardware store.
● THINNING ArmorPoxy may be thinned by adding up to 1/2 cup (4 oz) of xylene (xylol) per gallon
of mixed materials
● FIRST AID For skin contact, wash thoroughly with soap and warm water. In case of contact with
eyes, flush with warm water and immediately contact a physician or go to the emergency room
of your local medical center or hospital. If swallowed, do not induce vomiting. Contact a
physician and the poison control center.
4