Use and Care Manual
ARMOR NO PREP PRIMER INSTRUCTIONS
DESCRIPTION
Armor No Prep Primer is a 1-Part nano coating that can be used to prime surfaces that are already
coated and removing the coating by mechanical means will be too laborious or the environment does
not allow for it. Armor No Prep Primer can be used IN ADDITION to the ArmoTallic Metallic Coating
Kit as the first primer layer coat. Below are detailed instructions should you purchase the Armor No
Prep Primer. This product IS NOT INCLUDED with kits and MUST be purchased separately directly
from Armorpoxy, Inc.
SURFACE PREPARATION PREPARATION
Protect all surfaces not designated for coating application. Do not apply to surfaces that are frozen,
dirty, or have standing water, grease, oil or other contaminants. Intended surfaces must be clean, dry
and absorbent. Confirm surface absorbency with a light water spray - intended surface should wet
uniformly. If the surface does not wet uniformly, use a recommended cleaner, auto scrubber, power
washer or other process to remove surface contaminants. Surface must be clean and dry prior to
application.
NEW CONCRETE
Remove all dust, debris, and other contaminants from the surface. If concrete is less than 28 days
old, Armor Green HLT must be used prior to No Prep Primer. With Armor Green HLT new concrete
can be coated 96 hours after pour. Refer to Armor Green HLT application instructions and TDS for
how to install properly.
EXISTING CONCRETE
Intended surface must be clean, dry and structurally sound. Remove any and all contaminants
including bond breakers, surface grease and oil, dust and construction debris. For larger surface
areas, use an auto scrubber with an appropriate cleaner. Surface must be dry prior to application of
Armorpoxy products.
SURFACE & AIR TEMPERATURE
45 - 105F (7 - 40C)
EQUIPMENT
For horizontal substrates, use an acetone-proof pump sprayer with a cone tip. For vertical/upright
substrates, use an HVLP spray gun.
STORAGE & HANDLING
Store in a cool, dry place <80F. Always seal the container after dispensing. Published shelf life
assumes upright storage of factory-sealed containers in a dry place <80F.
PRE-APPLICATION
12