Use and Care Manual
BEFORE YOU START
● SUPPLIES You need to supply the following items: standard 9” roller frame, painting extension pole, and
power drill as these items are not included in the kit. Other suggested items are measuring cups, roller tray
(for the topcoat), a plastic or cloth drop cloth to mix on and xylene or similar cleaner and rags for cleaning
hands or drips.
● ETCH ArmorPoxy’s Etch is a mild, powdered citric-based cleaning agent. It is not dangerous, however it is
best practice to always wear protective eyewear, rubber gloves, and keep skin covered when applying.
● OLDER, STAINED, FIBER REINFORCED OR HIGHLY POLISHED CONCRETE Concrete that has been in
service for extended periods of time, particularly garage floors, becomes polished from the repeated trac in
the common areas. Also, impurities and chemicals from tires become trapped in the porous surface. The use
of tire shine products like ‘Armorall’ also creates resistance to most coatings. These conditions may require
additional treatment to create a strong bond for ArmorPoxy’s coatings.
● SURFACE PREP IS THE MOST CRITICAL STEP to assure peak performance of the ArmorPower epoxy kit
system. It is important to apply the product to a clean, well-prepared surface. The surface must be free of
debris, loose or flaking concrete, dirt, oil, curing compounds, previous coatings, sealers, and loose paint. Even
new concrete must be cleaned to remove dirt, dust, and salts that form as the concrete cures.
DO NOT SKIP THE PREP STEP. IF FLOOR IS NOT PREPPED FAILURE OR UNEVEN OUTCOME CAN
OCCUR.
● SAFETY As with any chemicals, avoid contact with skin, avoid inhalation and wear protective clothing, rubber
gloves and eye protection. Apply only in well-ventilated areas. Follow all local, state, and federal regulations
that may apply to your region. See our website at www.armorpoxy.com for Safety Data Sheet sheets.
● CLEAN UP Clean up with xylene (xylol) available at any paint or hardware store.
● THINNING ArmorPoxy may be thinned by adding up to 1/2 cup (4 oz) of xylene (xylol) per gallon of mixed
materials
● FIRST AID For skin contact, wash thoroughly with soap and warm water. In case of contact with eyes, flush
with warm water and immediately contact a physician or go to the emergency room of your local medical
center or hospital. If swallowed, do not induce vomiting. Contact a physician and the poison control center.
4