Use and Care Manual
● To test for moisture before you coat, use duct tape to tape down a sheet of 4’ x 4’ clear plastic. Tape down all 4 sides
completely. Wait 24 hours. Check for moisture buildup under the plastic. If moisture builds up then moisture is present in
the floor. Contact ArmorPoxy immediately for next steps before applying new coatings.
Can I apply multiple coats of ArmorPoxy over a period of time?
● Yes, no special surface prep is required if the additional coats are applied within 3-5 days. If a longer period goes by, then
the area should be sanded lightly to create a rougher surface to which the ArmorPower epoxy kit can adhere to.
Do I really need to add the anti-slip aggregate to the glaze coat?
● Any coated surface, especially a high quality smooth surface, can be slippery when wet or when exposed to oils and
grease. As a safety feature, we highly recommend that the anti-slip aggregate be added to the final coat.
I have some cracks in my floor. Should I fill these in before applying the ArmorPoxy?
● Filling the cracks may yield a smoother, more aesthetically pleasing floor since any liquid coating will not fill in cracks
100%. If you have cracks, our Epoxy Crack Filler kit works very well for hairline and smaller cracks. Urethane or epoxy
caulks may also be used. Another idea is to hide the cracks with the decorative chips. Do not use silicone-type caulks or
fillers, as they will resist the epoxy.
How long should I wait between coats and when can I use my garage after final application?
● We recommend waiting overnight between coats. Once the final coat is applied you can put your belongings back on the
floor the following day when the floor is cured enough to walk on. Vehicular trac and heavy equipment/storage units
should wait 4-5 days before being brought back onto the floor.
11