INSTALLATION INSTRUCTIONS Armorlite™ Front and Rear Flooring Vehicle Application Jeep Gladiator JT 4-Door ® DRAIN PLUG FR ON T D AR O INB DRAIN PLUG AR RE DRAIN PLUG RD A O TB U O GO R CA DRAIN PLUG
Armorlite Safety Information Vehicle Application Jeep Gladiator JT CAUTION READ BEFORE INSTALLING • DO NOT install Armorlite flooring on top of any existing flooring product, including factory or aftermarket systems, floor mats, carpets or linings of any type. • Armorlite flooring fit could be compromised if installed over a spray-in floor liner due to the additional thickness.
Vehicle Application Jeep Gladiator JT Armorlite Safety Information BEFORE YOU BEGIN INSTALLATION Wear gloves to protect your hands from any sharp edges in and around the seats. P Ensure the car is in “Park,” and the emergency brake is applied. • A second person will help to expedite the installation process. • Remove factory installed flooring, drain plugs and retainer clips that coincide with Armorlite purchased product.
FLOORING INSTRUCTIONS 1 Protect seat side shields. 3 Remove front floor mats. 2 Remove rear floor mats.
4 Remove front sill, electrical connector block and the door harness connector. There are several snap fasteners holding the door sill in place. Pull with steady force with both hands to remove. 5 Remove front and rear seat bolts. Depending on year seat bolts would require either a T50 Torx or an E14 Torx socket. * E14 Torx Socket * T50 Torx Socket 6 Remove B-pillar (mid & lower). 7 Remove rear console bolt trim covers.
8 Remove rear console bolts. 9 Remove front console bolt covers. 10 Remove front console bolts. 11 Remove rear carpet, if applicable (for rear installation only). 12 Remove these items from under the rear seat of the JT before removing factory carpet: storage box, scissor jack, and bolt storage box.
13 Remove front factory carpets. 14 Unscrew plastic floor mat posts. 15 Remove factory plugs (2 front, 2 rear). The factory carpet from the cargo area should overlap the Armorlite flooring on the waterfall under the rear bench seat. 16 Install rear Armorlite flooring, if applicable. 17 Install front passenger side Armorlite flooring. 18 Install front driver side Armorlite flooring. The rear flooring section should overlap the front sections under the front driver and passenger seats.
19 To ensure your Armorlite floor is properly positioned in the floor pan, properly install the Armorlite drain plugs in all four holes before replacing bolts and trim pieces (2 front, 2 rear). Reference Drain Plug Installation Instructions. 20 Install B-pillar. 21 Install front sill. 22 Install front and rear seat bolts at a torque specification of 48 newton meters. 23 Install rear console bolts & trim covers.
24 Install front console bolts and trim covers. 25 Reinstall these items under the rear seat of the JT: storage box, scissor jack, and bolt storage box. (FOR JT GLADIATOR MODELS ONLY) Installation of the flooring is complete.
LIMITED LIFETIME WARRANTY Armorlite flooring products are backed by a limited lifetime warranty for materials and workmanship, which means that our products are guaranteed not to break, tear, or deform under normal use. This limited warranty only applies when the product is correctly installed and used in the type of vehicle listed in the product description.
GOARMORLITE.
