Safety Data Sheets (SDS)

Table Of Contents
Skin protection
- Hand protection
Wear suitable gloves. Chemical protection gloves are suitable, which are tested according to EN 374. Check leak-tight-
ness/impermeability prior to use. In the case of wanting to use the gloves again, clean them before taking off and air
them well. For special purposes, it is recommended to check the resistance to chemicals of the protective gloves men-
tioned above together with the supplier of these gloves.
- Other protection measures
Take recovery periods for skin regeneration. Preventive skin protection (barrier creams/ointments) is recommended.
Wash hands thoroughly after handling.
Respiratory protection
In case of inadequate ventilation wear respiratory protection.
Environmental exposure controls
Use appropriate container to avoid environmental contamination. Keep away from drains, surface and ground water.
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Appearance
Physical state liquid
Color various
Odor characteristic
Other safety parameters
pH (value) not determined
Melting point/freezing point not determined
Initial boiling point and boiling range 100 °C
Flash point not determined
Evaporation rate not determined
Flammability (solid, gas) not relevant, (fluid)
Explosive limits not determined
Vapor pressure 0 Pa at 25 °C
Safety Data Sheet
acc. to 29 CFR 1910.1200 App D
Armor All Extreme Shield + Ceramic Car Wash - Concentrate
Version number: 3.0
Replaces version of: 2020-09-12 (2)
Revision: 2020-10-21
United States: en
Page: 6 / 15