Safety Data Sheets (SDS)

Safety Data Sheet
STP Products Manufacturing Company
44 Old Ridgebury Road
Suite 300
Danbury, CT 06810
Tel. [phone]
Armor All® FRESHfx Carpet and Upholstery Scrubby - New Car Aerosol Page 3 of 6
Environmental Precautions: Prevent entry into storm sewers and waterways. Report spill as required by local and
national regulations.
7. Handling and Storage
Precautions for Safe Handling: Avoid contact with eyes, skin, and clothing. Use with adequate ventilation. Wash
thoroughly with soap and water after handling. Keep out of the reach of children. Do not puncture or incinerate
containers.
Conditions for Safe Storage, Including any Incompatibilities: Store in a cool, well-ventilated area, away from
incompatible materials. Do not store in direct sunlight or above 120°F. U.F.C. (NFPA 30B) Level 1 Aerosol.
8. Exposure Controls / Personal Protection
Exposure Guidelines:
CHEMICAL
EXPOSURE LIMIT
Propane
1000 ppm TWA OSHA PEL
Butane
1000 ppm STEL ACGIH TLV
Diethylene Glycol monobutyl ether
10 ppm TWA ACGIH TLV (Inhalable fraction and vapor)
Sodium lauroyl sarcosinate
None Established
Morpholine
20 ppm TWA OSHA PEL (Skin)
20 ppm TWA ACGIH TLV (Skin)
Appropriate Engineering Controls: General ventilation should be adequate for all normal use. For operations
where the TLV may be exceeded, forced ventilation such as local exhaust may be needed to maintain exposures
below applicable limits.
Personal Protective Equipment
Respiratory Protection: None under normal use conditions. For operations where the TLV may be exceeded, a
NIOSH approved respirator with an organic vapor cartridge and a dust/mist prefilter or supplied air respirator is
recommended. Equipment selection depends on contaminant type and concentration. Select in accordance with
29 CFR 1910.134, all applicable laws and regulations, and good industrial hygiene practice.
Gloves: Impervious gloves are recommended for prolonged or repeated skin contact.
Eye Protection: Safety glasses or goggles are recommended if eye contact is possible.
Other Protective Equipment/Clothing: Appropriate protective clothing as needed to prevent prolonged/ repeated
skin contact.
9. Physical and Chemical Properties
Appearance and Odor: White foam in an aerosol can.
Physical State: Liquid-based aerosol
Odor Threshold: Not available
pH: Not determined
Specific Gravity: Not determined
Initial Boiling Point/Range: Not determined
Vapor Pressure: Not determined
Melting/Freezing Point: Not determined
Vapor Density: Not determined
Solubility In Water: Complete
Percent Volatile: Not determined
Viscosity: Not determined
Evaporation Rate: Not determined