SDS

Safety Data Sheet
The Armor All/STP Products Company
44 Old Ridgebury Road
Suite 300
Danbury, CT 06810
Tel. [phone]
Armor All® FRESHfx™ Arctic Cool™ Vent Clip Page 4 of 6
(R)-p-Mentha-1,8-diene None Established
Bornan-2-one
2 ppm TWA, 3 ppm STEL ACGIH TLV
2 mg/m3 TWA OSHA PEL
Cineole None Established
Pin-2(3)-ene 20 ppm TWA ACGIH TLV (DSEN)
Tetrahydro-4-methyl-2-(2-methylprop-1-
enyl)pyran
None Established
Appropriate Engineering Controls: General ventilation should be adequate for all normal use.
Personal Protective Equipment:
Respiratory Protection: None required under normal use conditions.
Gloves: None normally required. Avoid prolonged skin contact. Impervious gloves such as rubber, neoprene or
nitrile can be used if needed to avoid prolonged or repeated skin contact.
Eye Protection: None required for normal use. Safety glasses or goggles are recommended if eye contact is
possible.
Other Protective Equipment/Clothing: None required under normal use conditions.
9. Physical and Chemical Properties
Appearance And Odor: Pale yellow to yellow liquid with a characteristic odor contained in a vapor permeable
membrane within a plastic clip.
Physical State: Liquid-based aerosol Odor Threshold: Not available
pH: Not determined Specific Gravity: Not determined
Initial Boiling Point/Range: Not determined Vapor Pressure: Not determined
Melting/Freezing Point: Not determined Vapor Density: Not determined
Solubility In Water: Not determined Percent Volatile: Not determined
Viscosity: Not determined Evaporation Rate: Not determined
Coefficient Of Water/Oil Distribution: Not determined VOC Content: Not determined
Flash Point: 165.2F (74C)
Autoignition Temp: Not determined
Flammability Limits: LEL: Not available
UEL: Not available
Flame extension: Not applicable
Decomposition Temperature: Not available Flammability (solid, gas): Not applicable
10. Stability and Reactivity
Reactivity: Not normally reactive.
Chemical Stability: Stable under normal storage and handling conditions.
Possibility of Hazardous Reactions: None known
Conditions to Avoid: Keep away from excessive heat and open flames.
Incompatible Materials: Strong oxidizing agents, strong acids, and strong bases.
Hazardous Decomposition Products: Oxides of carbon and unburned hydrocarbons.