Technical data
27
CAUTION:
Avoid exposing the device to bright light sources such as relight, headlights, searchlights, etc.,
as these can damage the CO-MINI.
5. To operate the CO-MINI in short-time activation mode, put the device in standby mode. To activate
the CO-MINI, press and hold the remote control button. Release the remote control button to deac-
tivate the CO-MINI.
6. Observe the scene. Adjust the image contrast by rotating the gain control knob (CO-MINI MG only).
7. If the day scope includes a focusing ring (i.e., parallax adjustment knob), adjust the focus for a paral-
lax-free image.
8. Turn on the day scope’s reticle illumination and adjust the reticle brightness.
CAUTION:
Do not leave the CO-MINI activated if it is not being used.
NOTE:
Automatic interrupting time is 60 minutes. To resume operation, you will need to restart the
CO-MINI.
3.3.2 OPERATING THE IR850
Use the IR850 in poor light conditions or complete darkness.
CAUTION:
The light from the IR illuminator will be invisible to the naked eye. However, the light can be
detected by other NVDs.
CAUTION:
Do not leave the IR850 activated when the device is not in use.
1. After examining a scene with the CO-MINI, turn on the IR850.
2. To change the radiated power level, turn the power switch to one of the spots between the two OFF
positions.
3. To adjust the IR beam divergence, rotate the lens.
4. ToadjusttheIRspotpositionintheeldofview,loosentheclampscrewandtilttheIR850asre-
quired. Tighten the screw using a 2.5mm hex key.
3.3.3 OPERATING IN CHANGING LIGHT CONDITIONS
If a mission must be carried out in changing light conditions, you can deactivate the bright light protec-
tion system of the CO-MINI. To shut down the protection system, close the photoreceiver by ipping
up the pivoted shutter.
CAUTION:
After your mission is complete, open the photoreceiver by ipping the pivoted shutter down.