Technical data

CAUTION:

When loosening the ring (E), only utilize the two auxiliary, non-threaded holes (D). Avoid using

the threaded ones.

4. Usingaturningmachine,cuttheinsidefaceofthering(E).Thevalueofcutting(inmillimeters)is

equaltothevalueoftheturningangle(inangulardegrees)dividedby360°.

5. With the cut end directed inwards, screw the ring (E) into the adapter’s body and tighten it.

6. Applyasmallamountofthreadlocktothethreads.Axthering(E)withtwoM2×2.5screws(F).

3.1.7 FASTENING A WIRELESS REMOTE CONTROL UNIT TO WEAPON

Using Velcro tape (A), fasten the remote control unit (B) (Figure 3-12) to the weapon in an easily acces-

sible place (e.g., on the front of the rie stock) on the side of the CO-MINI’s wired cover preferably.

If your rie has a Picatinny or Weaver rail on the forend you can use the Picatinny adaptor for Advanced

Wireless Remote (C). Install adaptor on the rail. Insert the remote control unit in the adapter.

FIGURE 312. ADVANCED WIRELESS REMOTE CONTROL

3.1.8 INSTALLING THE IR850

The IR850 (Figure 3-13) is delivered ready-assembled with a dedicated mount, to be installed on the

Weaver rail of the CO-MINI. The mount clamp (A) has a spherical hinge that allows the operator to tilt

the IR850 as desired.

Mount the IR850 on the Weaver rail as follows:

1. With the nut (D) loosened, install the mount (B) onto the Weaver rail so that the stop (C) slides into

one of the transverse slots of the rail.

2. Tighten the nut (D) with a screwdriver.

FIGURE 313. IR850 ILLUMINATOR