Technical data

23
2. Takeotheoutputlenscapandplaceitintothestoragecase.
3. With the nut (B) loosened, position the insert (C) into the adapter’s clamp (A).
4. ScrewtheadapterintotheCO-MINI’soutputlensthread.
5. With the nut (B) loosened, slide the CO-MINI, with the adapter, onto the lens of the day scope as far
as it will go.
6. Tighten the nut (B) with a screwdriver.
NOTE:
The second Weaver rail can be installed in place of the removed mount.
If the position of the adapter’s clamping nut is undesirable, it can be adjusted by performing the fol-
lowing:
1. Decide on desirable position of the nut and estimate the angle through which the adapter should be
turned CW (see Figure 3-11).
2. Remove the adapter from the CO-MINI.
3. Usingascrewdriver,removebothscrewsM2×2.5(F,seeFigure 3-10) and then unscrew the ring (E).
A
B
C
D
E
F
FIGURE 310. SCOPE MOUNTING SYSTEM
DESIRABLE POSITION
OF THE NUT
NUT
FIGURE 311. ESTIMATION OF THE ADAPTER TURNING ANGLE