Technical data

22
The fully assembled CO-MINI with the raiser is shown in Figure 3-8.
3. ToinstalltheCO-MINIonaPicatinny/WeaverrailinfrontofACOG4×32scope,refertoPart3.1.3.
3.1.6 INSTALLING THE COMINI ONTO THE LENS OF A DAY SCOPE
To install the CO-MINI onto a day scope, use the optional adapters.
NOTE:
The attaching diameters of the adapters dier, and must t with the day scope parameters
specied in Table 2-8 (Scope Mounting Systems Data).
NOTE:
The CO-MINI cannot be attached to the scope if there is a focus ring attached to the objective
lens’ housing.
CAUTION:
The Scope Mounting Systems are not recommended for installing the CO-MINI on rearms that
have vigorous recoil (0.308 Win or stronger).
Figure3-9showstheCO-MINIinstalledonthelensofadayscope.
To install the CO-MINI on the lens of a day scope, do the following (refer to Figure 3-10):
1. Using a 2.5mm Allen key, unscrew both М4×8 xing screws on the CO-MINI mount. Remove the
mount from the seating rail and place it, along with the screws, into the storage case.
FIGURE 38. THE COMINI READYASSEMBLED WITH THE RAISER
FIGURE 39. THE COMINI INSTALLED ON THE LENS OF A DAY SCOPE