Technical data

ManualsBrandsArmasight ManualsMonocularPVS-14/6015

ITEM

NO.

INTERVAL CHECK/SERVICE PROCEDURE NOT FULLY MISSION CAPABLE IF...

21 Before

/After

Compass Inspect for dirt, dust, scratches, or

damage. If necessary, clean with water

and dry with lens tissue.

Install compass and turn on monocu-

lar. When the illumination button is

depressed, compass should be visible.

Damaged; compass is not

visible.

22 Before

/After

3X Magnier

(Additional

Authorized

Item)

Inspect optical surface for dirt, dust,

scratches or cracks.

Damage; scratches hinder

vision.

Before

/After

Case

CARRYING CASE

Remove all items and shake out loose

dirt or foreign material. Inspect for

tears, cuts, excess wear, or damage to

mounting clips.

24 Before

/After

Shoulder

Strap

Inspect for cuts, tears, or excess wear

or damaged clips.

3.2.2. RESOLUTION CHECK USING THE TS4348/ UV TEST SET

NOTE:

The TS-4348/ UV Test Set can be used by the operator to check the resolution of a monocular

at any time.

NOTE:

The TS-4348/ UV Test Set can be used by Direct Support/Intermediate Level to perform the res-

olution testing 180 Day Service. If a system fails it must be tested on the TS-3895A/UV Test Set.

NOTE:

Verify the resolution of the monocular using the TS-4348/ UV Test Set at every opportunity. The

resolution cannot be accurately measured without the test set.

The following procedures are designed to check the performance of the image intensier.

a. Setup

Before using the TS-4348/ UV Test Set, familiarize yourself with its operation and specic warnings and

cautions.

TABLE 31. CONTINUED

Shop for Armasight products online at:

1.877.766.5412