Technical data

25
TABLE 31. COMR CONTROLS AND INDICATOR
ITEM NO. CONTROL/INDICATOR FUNCTION
1 Turn-Pull Switch Activates the CO-MR, when turned to ON position.
NOTE:
Both ON and “BATTERY” end positions of the switch can only be entered
if the spindle is pulled before turning.
Actuates the battery check mode, when turned to “BATTERY” position (see
note above).
Actuates standby mode, when turned to STB.
Deactivates the CO-MR, when turned to OFF.
2 Bi-color LED
Indicator
PERMANENT GREEN GLOW indicates excessive light conditions. After 10
secondstheimageintensiertubewillbecuto.TheCO-MRturnsback
again when moved away from the excessive light.
PERMANENT RED GLOW indicates usable condition of the battery.
FLASHINGREDLIGHTindicatesalowbattery.
3 Gain Control
Knob*
Adjusts the brightness of the image.
4 FocusKnob Focuses the objective lens. Adjusts for sharpest view of the scene. The
total focus range is covered with 0.5 turn of the knob. Directions of focus
(sharper to softer) are designated by a double arrow on the knob.
- Remote Control
Button
Activates/deactivates the CO-MR in standby when pressed/released.
*For CO-LR MG model only
3.2.2 IR850 CONTROLS
TheIR850controlsareshowninFigure3-14anddenedinTable3-2.TheITEMNO.columnindicatesthe
numberusedtoidentifyitemsinFigure3-14.
TABLE 32. IR850 CONTROLS
ITEM NO. CONTROL/INDICATOR FUNCTION
1 Power Switch SwitchestheIR850on/oandadjustsforradiatedpower.Fouron-posi-
tions are located between two OFF positions, and are each marked with a
dierent-sizedspot.Thelargerthespot,thegreatertheradiatedpower.
2 Lens Adjusts for IR beam divergence. Adjustment range is covered with ap-
proximately one turn of the lens.
FIGURE 314. IR850 CONTROLS
B
A