Technical data

3.1.6 INSTALLING THE PLATFORM RING ON A DAY SCOPE

TheplatformringinstalledonadayscopeisshowninFigure3-4.

Install the platform ring on the mounting tube of the day scope as follows (refer to Figure 3-10):

1. Using a 3 mm hex key, unscrew the both clamp screws (C).

2. Place the ring’s clamps (D, E) onto the scope’s mounting tube with/ without the pair of inserts (A), de-

pendingonthemountingtubesize(25.4/30mmrespectively).Screwtheclampstogetherwithout

tightening the screws (C).

3. Adjust position of the platform ring until its Weaver rail (B) is level. Apply a small amount of thread

lock to the threads and tighten the screws (C).

3.1.7 INSTALLING THE WEAVER RAIL ON THE COMR

The CO-MR with the optional Weaver rail is shown in Figure 3-7.

Install the Weaver rail on the CO-MR as follows:

1. Using a 2.5 mm Allen key, unscrew the both М4×8 screws xing the CO-MRmount. Remove the

mount from its seating rail and put it into the storage case.

2. Install the Weaver rail in place of the removed mount, and after applying a small amount of thread

locktothethreads,axtherailwiththetwoM4×8screws.

3.1.8 FASTENING A ADVANCED WIRELESS REMOTE CONTROL TO WEAPON

Using Velcro tape (A), fasten the Advanced Wireless Remote Control (B) (Figure 3-11) to your weapon in

an easily accessible place (e.g., on the front of the rie stock) on the side of the CO-LR’s control compart-

ment preferably.

If your rie has a Picatinny or Weaver rail on the forend you can use the Picatinny adaptor for Advanced

Wireless Remote (C). Install adaptor on the rail. Insert the remote control unit in the adapter.

FIGURE 311. ADVANCED WIRELESS REMOTE CONTROL

FIGURE 310. PLATFORM RING