Technical data

3.1.4 CLAMPING DEVICE ADJUSTMENT

Adjust the mount clamping device as follows (refer to Figure 3-6):

1. Unlock the clamping device and remove the CO-MR from the weapon.

2. To tighten/loosen the clamping device, push the cam (C) towards the arrow (which will cause the nut

(A) to slide out of its hollow) and turn the nut (A) CW/CCW respectively, in one-two increments (see

note below). Much like when the cam (C) is released, backward-moving springs will cause the nut (A)

to slide back into its hollow.

NOTE:

The eight-sided nut of the clamping device will only t into its hollow if turned in one of the

discretepositionsusingincrementequalto360°/8.

4. Verifythattheadjustedlever-camlockholdstheweapon/TAMmountingrailrmly.

5. Repeat the procedure to adjust the clamping device’s second lever-cam lock.

3.1.5 INSTALLING THE COMR ON THE LENS OF A DAY SCOPE

Use the optional Scope Mounting System (SMS) to install the CO-MR on the lenses of day scopes.

NOTE:

Theadaptersdierinattachingdiametersandmusttwiththedayscopeparametersspecied

inTable2-9(ScopeMountingSystemsData).

NOTE:

The CO-MR cannot be attached to the scope having a focus ring on the objective lens’ hous-

ing.

CAUTION:

The Scope Mounting Systems are not recommended for installing the CO-MR on rearms hav-

ing vigorous recoil (0.308 Win or stronger).

The CO-MR installed on the lens of a day scope is shown in Figure 3-7.

Install the CO-MR on the lens of a day scope as follows (refer to Figure 3-8):

1. Using a 2.5 mm Allen key, unscrew the both М4×8 screws xing the CO-MRmount. Remove the

mount from its seating rail and put it with the screws into the storage case.

FIGURE 37. THE COMR INSTALLED ON THE LENS OF A DAY SCOPE