Technical data

20
NOTE:
Optical axes of the CO-MR and day scope should align. It is not recommended for the distance
betweentheaxestoexceed3mm.IfthedierenceintheaxisheightsoftheCO-MRandday
scope above the weapon rail exceeds 3 mm, you will need to replace the day scope mounting
rings or monoblock.
Install the CO-MR on a Picatinny/ Weaver rail in front of a day scope as follows:
1. Unscrew the output lens cap and place it in the storage case.
2. Remove the light suppressor from the storage case. Screw it into the output lens’ thread in place of
the cap.
3. Unlock the clamping device of the CO-MR mount by pushing down on the lever holder (B, see Figure
3-5) and unlocking the cam lever (A).
4. InstalltheCO-MRonthePicatinny/Weaverrailinfrontofthedayscopesothatthestop(B,seeFigure
3-6) slides into one of the rail’s transverse slots. The light suppressor should cover the day scope’s
objective lens.
5. Ax the CO-MR to the rail by locking the cam lever (A, see Figure 3-5).
6. Verify that the clamping device is rmly holding the CO-MR. If necessary, adjust the clamping device
asdetailedinPart3.1.4(ClampingDeviceAdjustment).
Figure3-4showstheCO-MRandadayscopeinstalledwiththeoptionalExtendedRailAdapteron a
weapon, using a short-mounting Picatinny/ Weaver rail.
FIGURE 34. THE COMR ON A PICATINNY RAIL IN FRONT OF A DAY SCOPE
FIGURE 35. MOUNT. TOP VIEW
B
A
LOCKED
POSITION
UNLOCK
POSITION
FIGURE 36. MOUNT. UNDERSIDE VIEW
A B C
UNLOCK
POSITION
LOCKED
POSITION